Filter
Top Products
1
Connect the power cord to your
projector and plug the other end
into an electrical outlet.
2
Remove the lens cover.
3
Locate the projector’s remote control
and turn it over. Push down on the
ridges at one end of the battery cover
as you slide the cover off.
4
Locate the batteries that came with
your projector and insert them as
shown. Then replace the battery cover.
5
Push up on the remote control’s on/off
switch to turn it on.
6
Aim the remote control at the projector
and press the Power button. The
projector’s power light flashes green,
and then stays on.
7
Turn on or restart your laptop. (Windows
®
only:
If you see a New Hardware screen, click Cancel.)
Tu rn over
Turn on your equipment
Connect the projector
to your laptop
Power cord VGA computer cable
Follow these instructions to connect the projector
to your laptop. To connect other devices, such as
a VCR or desktop PC, see your User’s Guide.
EPSON
®
PowerLite
®
7800p
Quick Setup
CAUTION: Before unplugging the projector...
To shut the projector down properly:
1. Press the Power button twice. Let the projector cool while
the power light flashes orange (about 30 seconds).
2. Once the light stops flashing and stays on, it’s safe to unplug
the projector.
Never unplug the projector when the power light is green or
flashing orange.
For most setups, you’ll need just these two cables:
1
Make sure your projector and laptop are turned off.
2
Connect one end of the VGA computer cable to the
Computer port on the projector.
3
Connect the other end to your laptop’s video-out or monitor
port. If you can’t connect the cable to your PowerBook,
®
you may
need to use an adapter. See your User’s Guide for instructions.
Lens cover
Ridges
On/off
switch