Filter
Top Products
ESC/VP21 Communication Manual Home
7 of 8
5.Appendix
A projector and a computer can be connected using a serial or USB port. The projector can be remotely controlled by sending commands to the
projector..
Serial Connection (TW100,TS10,TW10,TW200,TW500,TW10H,TW200H,TW20,TW600/520/550/800,TW700,TW1000,TW2000)
• Select RS-232C at Advanced Setting of the Menu.
• Communication condition
Baud rate : 9600 bps
Data length : 8 bits
Parity : No
Stop bit : 1 bit
Flow control : No
• Connector : D-sub 9pin
• Projector input : Control(RS-232C)
*Theres no effect if DTR and DSR are not used.
USB Connection (TS10,TW200,TW500,TW200H)
• TS10, select USB at Advanced Setting of the Menu.
• Epson USB VCOM Driver has to be installed in your computer to use USB fpr communication.A COM port is added to your
computer, when the projector and your computer is connected by a USB cable. The added COM is listed at PORT (COM/LPT)
in the device manager tab of System in Control Panel as EPSON COM Emulation port (COMn).
• Connector : USB(B type)
<Projector> (PC serial cable) <Computer>
GND 5 5 GND
RD 2 3 TD
TD 3 2 RD
Signal name Function
GND Common ground
TD Transmitted data
RD Received data
<Projector> <Computer>
<Projector> <Computer>