Filter
Top Products
2
7. After a few moments, the display on the front of the unit should show Output=720P
60Hz
.
If it does not, press the
POWER button on the remote control to place the video
processor in Setup Mode. (You see Setup Mode on the display.)
Press the
Menu button. Then use the u and d buttons to select the output
resolution setting (“OUT = xxx”). Use the l and r buttons to change the setting
to
OUT = 720p 60 Hz.
Press the
POWER button on the remote control to return the video processor to On
Mode.
8. Remove the protective lens pad from the projector, then remove the lens cap.
9. Plug in the power cord. Make sure batteries are installed in the projector remote control.
10. Turn on the power switch on the back of the projector, then press the
On button on the
remote control.
Power switch
Turn on the
projector