Filter
Top Products
Chapter 2 Connecting the Cables
2-1
Connecting the AC Adapter to the Printer
Follow these steps to connect the AC adapter to the printer:
➀ Make sure the printer is turned off. It is off when the O side of the switch is
pressed down.
➁ Check the label on the AC adapter to make sure the voltage required by the AC
adapter matches that of your electrical outlet.
CAUTIONS:
l To avoid damage to the AC adapter and the printer,
or to avoid an incor-
rect operation of the printer, do not plug in the power cord, if the rated
voltage of the AC adapter and your outlet voltage do not match.
➂ Plug the DC cord connector into the printer’s power connector with the arrow
mark facing upward.(You can remove the DC cord by grasping the connector
firmly at the arrow mark and pulling it straight out.)
Power Connector
Frame Ground Screw -----
Frame ground cable
AC Adapter
➃ Ground the printer by connecting a frame ground cable (*1) to the printer with
the frame ground screw located on the bottom of the printer.
(*1) This cable is not enclosed. Please obtain the appropriate cable for your
system.
➄ Plug the AC adapter power cord into the wall outlet.
5