Filter
Top Products
E-58
STANDBYSTATUS
STANDBYSTATUS
STANDBYSTATUS
STANDBYSTATUS
STANDBYSTATUS
STANDBYSTATUS
STANDBY indicator
When an Indicator is Lit or Blinking
The indicators on the projector’s control panel lit or blink to
notify of problems, as described below.
An indicator is also used to notify you of the currently set
power mode (under normal circumstances). See “Power Cable
Connections and Switching the Power On/Off” on page E-22.
Indicator status What you should do
When the power is on (Lit green)
Standby (Lit amber)
Lit red
Blinks amber for 60 seconds, then lit
amber
Lit red
Lit red
Blinks red
(lit for 1 seconds/off for 1 seconds)
Lit red
Blinks red
(lit for 0.5 seconds/off for 0.5 seconds)
Lit amber
Blinks red
(lit for 0.5 seconds/off for 0.5 seconds)
When the lamp has burned out
during use
Blinks amber for 90 seconds, then lit
amber
When the lamp does not come on
from the start
Lit amber
Blinks red
(lit for 1 seconds/off for 1 seconds)
It is time to replace the lamp.
Replace with a new lamp cartridge.
The lamp has reached the end of its service life. The power
will no longer turn on.
The projector can be used for 100 hours after the lamp has
reached the end of its service life.
Replace with a new lamp cartridge.
The lamp cover is open.
The lamp cover is not properly mounted. Mount it properly.
The temperature is abnormally high.
• Refer to “About the Temperature Protector” below.
The fan has stopped.
Unplug the power cable and contact a store that sells the U7-
132/U7-137 for repairs.
The lamp will not light.
Wait at least 90 seconds, then turn the power back on. If the
problem persists, unplug the power cord and contact a store
that sells the U7-132/U7-137 for repairs.
Should an indicator be in a condition other than normal or flash at a rate other than the aforementioned, disconnect the power
cable and contact your store of purchase.
Thermal Protector
When the temperature inside the projector becomes abnormally high, the STATUS indicator blinks red (0.5 seconds on/0.5
seconds off), the STANDBY indicator is a steady red, and at the same time the temperature protector operates and switches off
the power of the projector.
Should this happen, please take the following actions.
1. Switch off the power and disconnect the power plug from the wall outlet.
2. Check the following matters and take the required measures.
When the projector is being used in a location that has a high ambient temperature, set it up again in a cool location. Check the
outflow and intake holes and clean them if they are obstructed.
3. Wait about 60 minutes until the temperature of the projector drops.
If after having performed the above matters, the problem still has not been solved, please contact your store of purchase.
STATUS indicator