Filter
Top Products
Network Menu
87
SNMP menu
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network
administrator.
Sub Menu Function
SNMP Set this parameter to On when using SNMP
g to monitor the projector.
Trap IP Address 1/Trap IP
Address 2
When SNMP is set to On, you can set up to two IP addresses as SNMP trap notification destinations.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Community Name Set the community name of SNMP. You can enter up to 32 single-byte alphanumeric characters.