ETA Systems ETA-C15D Power Supply User Manual


  Open as PDF
of 12
 
– 6 – ETAsys.com
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
KEY FEATURES
• 10TotalOutletsAreProvided
• 8RearPanelOutlets
• 2FrontPaneland1RearPanelUnswitchedConvenienceOutlets
• RFINoiseFilteringtoReduceRadioFrequencyInterference
• EMIToReduceElectromagneticInterference
• DualClampingSpike&SurgeSuppression,DCSCircuitry
• FrontPanelDigitalACMainsVoltmeter
• LEDIndicationofReversed“Live”and“Neutral”Wiring
• AbnormalACLineVoltageIndicatorforVoltagesBetween101V–107Vor128V–132V
• ExtremeVoltageShutdown(EVS)Below101VorAbove132VACLine
• CircuitBreakerProtection@15AIndicatedby“BreakerOpen”Indicator
• FrontMountedPull-outLEDLightWith2-PositionDimmer
• RearMountedXLRConnectorfor12VDCLEDLamp
APPLICATIONS
The ETA-C15D was designed to be flexible with features that allow it to be used in a variety of applications. The ETA-C15D can be used
solely for protection against lightning strikes or voltage surges or for AC Mains Voltage Monitoring. If fuzzy video or frequent static pops
occur, the AC power conditioning will eliminate or reduce those inconveniences. The following are just a few examples of applications
in which the ETA-C15D can be used:
• Restaurants
• HousesofWorship
• Schools
• HomeTheaters
• OfficeBuildings
• SportsBars
FRONT PANEL FEATURES
1. Unswitched AC Outlet–Thetwo120VACoutletsarealwayslivewhentheETA-C15DpowercordispluggedintoanACmains
power source and voltage is present. If voltage is present at the outlets, it will be displayed on the AC Mains Meter. Note: The AC
mains power switch does not affect the Unswitched AC Outlets. The Unswitched Outlets are protected by the surge protection
circuitry, but will not be shut off by the EVS circuit.
2. AC Mains Breaker –The15AratedbreakerwillopenifthecombineddrawofallACoutletsexceeds15A.Note:Thebreakersare
designed to exceed their rating for a short period of time. If the breaker is tripped, to reset you must first remove the load from the
ETA-C15D and push the center button in on the breaker.
3. Power Switch –ToturntheETA-C15Donoroff,presstheswitchtotheONorOFFposition.
4. Pull Out Light –TheLEDlightisdesignedtobepulledoutwhenneeded.
5. Pull Out Light Dimmer Switch–ThePullOutLightcanbeturned“On”or“Off”bythisswitch.Therearealsotwobrightness
settings.
ETA-C15D
Power Conditioner
2 3 4 5
1
 previous next