EVGA e-610i Computer Hardware User Manual


 
Preparing the Motherboard
Installing the CPU
Be very careful when handling the CPU. Hold the processor only by the edges
and do not touch the bottom of the processor.
Use the following procedure to install the CPU onto the motherboard.
1. Unhook the socket lever by pushing down and away from the socket.
2. Lift the load plate. There is a protective socket cover on the load plate to
protect the socket when there is no CPU installed.
3. Remove the protective socket cover from the load plate.
4. Remove the processor from its protective cover, making sure you hold it
only by the edges.
It is a good idea to save the cover so that whenever you remove the CPU,
you have a safe place to store it.
5. Align the notches in the processor with the notches on the socket.
6. Lower the processor straight down into the socket with out tilting or sliding
it into the socket
Note: Make sure the CPU is fully seated and level in the socket.
7. Close the load plate over the CPU and press down while you close and engage
the socket lever.
Installing the CPU heat sink/fan
There are many different heat sink types that can be used with this motherboard. Follow the
instruction that came with your fan assembly. Be sure that the fan orientation is correct for
your chassis type and your fan assembly.
Installing System Memory (DIMMs)
Your new motherboard has two 1.8V 240-pin slots for DDR2 memory. These slots support
256 MB, 512 MB, 1 GB, and 2 GB DDR2 technologies. There must be at least one memory
bank populated to ensure normal operation.
*Any of the two DIMM slots may be used as primary if only using one memory module.
1. Unlock a DIMM slot by pressing the module clips outward.
2. Align the memory module to the DIMM slot, and insert the module vertically into the
DIMM slot. The plastic clips at both sides of the DIMM slot automatically lock the
DIMM into the connector.
Align notches with
notches on the CPU