Filter
Top Products
Page 6 of 12 1005911
4
Installing the tape drive
4 Installing the tape drive
1.
Insert the tape drive so that the handle is at the top and the fan is at the
bottom, as shown in the following figure. The drive should slide easily
toward the front of the library.
2. Tighten the captive screws on each end of the drive carrier to
8.0 inch-pounds (9.2 kg-cm) of torque.
CAUTION
Do not install a mixture of Fibre Channel and SCSI tape
drives in the library. Mixing drive interfaces could
cause data loss.