Filter
Top Products
Cable Cubby 300/600/800 • Installation 6
Preparing the Table with a Router
Prepare the table with a router as follows:
ATTENTION: Potential damage to property. The routing templates for the various
Cable Cubby models are not interchangeable. If you use the wrong template, you will
cut an improperly sized hole. If you use a larger template than required, the cut will
result in gaps in the table surface on either side of the enclosure.
ATTENTION: Potential damage to property. Ensure that only the wooden strips
on the routing template contact the furniture. Failure to do so may scratch the furniture.
NOTE: The metal routing template is reusable. Do not discard the template when the
installation is complete. Save it for installing other Cable Cubby models of the same
size.
1. Mark the desired mounting location on the tabletop or other installation surface.
2. Place the mounting template assembly on the table, centered on the mounting location.
Angle the template for the optimum positioning. If necessary, use a square to ensure
that the template is properly positioned. Extron is not responsible for an improperly
positioned Cable Cubby.
3. Once the template assembly is positioned properly, secure the assembly to the table
with C-clamps.
CAUTION: Risk of injury to the eyes. Wear safety glasses when operating the
router. Failure to comply can result in eye injury.
4. Using a router with a 5/8 inch (or 16 mm) outside diameter guide bushing and a
1/2 inch (or 12 mm or 12.7 mm) diameter straight router bit, carefully cut the opening in
the surface (see figure 5).
HSA 200
USER ACCESS
HSA 200
CABLE CUBBY 300
CABLE CUBBY 300
USER ACCESS
Router
Figure 5. Cutting the Opening with a Router
5. Remove the C-clamps and the routing template.