Filter
Top Products
VersaTools
®
MTP 15HD A Series • InstallationVersaTools
®
MTP 15HD A Series • Installation
VersaTools
®
MTP 15HD A Series, cont’d
VersaTools
®
MTP 15HD A Series • Installation10
5. Mount the unit to the rack using the two included rack
screws (figure 4). The MTP can be vertically mounted
facing in either direction.
INPUT
AUDIO
MONITOR
POWER
12V
.5A MAX
OUTPUT
MTP T 15HD A
P
R
E
-P
E
A
K
O
N
O
F
F
MAV SERIES
AV MATRIX SW
ITCHE
R
I/O
A
UD
AUD
IO
SETUP
PRESET
VID
IR
+dB
-dB
ENTER
2
7
6
5
2
4
1
IN
PU
TS
O
U
TPU
TS
8
3
1
8
6
5
4
3
7
MTP SERIES
Rear
Front
Figure 4 — Typical back of the rack installations
Furniture or projector mounting
Use one of the following optional mounting kits to mount the
MTP under furniture or to a projector mount (figure 5).
• MBU 123 VersaTools under desk mounting kit,
part #70-212-01
• PMK 100 VersaTools mini projector mounting kit,
part #70-217-01
1. Remove the feet from the bottom of the MTP, if they are
installed.
2. Attach the mounting brackets to the MTP with the
provided machine screws.
3. For furniture mounting, hold the MTP with the attached
brackets against the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
4. For furniture mounting, drill 3/32" (2 mm) diameter pilot
holes, 1/4" (6.3 mm) deep in the mounting surface at the
marked screw locations.
Projector
Projector
Mounting
Bracket
Mounting
Bolt
PRE-PEAK
ON
OFF
IN
P
U
T
O
U
T
P
U
T
P
O
W
E
R
1
2
V
.5
A
M
A
X
T
x
R
x
R
S
-
2
3
2
MTP R 15 HD RS
O
N
1
2
3
4
5
6
H SYNC +
V SYNC +
C SYNC
SOG
VIDEO
SPARE
M
T
P
S
E
R
IE
S
Figure 5 — Desk and projector mounting the MTPs
5.
For furniture mounting, insert #8 wood screws into the
four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4
"
(6 mm) of the screw head
protrudes.
6. For furniture mounting, align the mounting screws with
the slots in the brackets and place the MTP against the
surface, with the screws through the bracket slots.
7. For furniture mounting, slide the MTP slightly forward or
back, then tighten all four screws to secure the MTP in place.
8. For projector mounting, secure the MTP to a projector
mount by inserting the mounting bolt through the
bracket’s slotted hole and tightening the bolt.
11