Filter
Top Products
RGB 138xi, RGB 158xi Installation and Operation
RGB 138xi, RGB 158xi Installation and Operation
Installation and Operation, cont’d
2-13
HI
G
H
VO
LT
AG
E
C
A
U
T
IO
N
Adapter Plate
Tighten nuts
securely
RGB 138 xi
IN
P
U
TS
A
U
D
IO
A
N
A
L
O
G
UNSWITCHED
600 WATTS MAX.
M
I
N
/M
A
X
M
B
C
PO
W
E
R
U
N
IV
E
R
S
A
L
IN
T
E
R
F
A
C
E
W
/A
D
S
P
Cable Routing
Routing adapter output cables and
attaching adapter plates
6. Insert the adapter plate screws through the holes in the
interface front panel, as shown above. Attach the
adapter plates to the enclosure with the provided
captive washers and #4-40 nuts.
7. Gently pull excess cable out the rear panel openings.
Do not strain or damage the cable-adapter
connections.
8. Fasten the cables in place by tightening the screws on
the cable clamps provided on the rear panel openings.
100-240 50/60 Hz 0.5A
9. Replace the top cover on the interface, and fasten it with
the screws removed in step 2.
2-12
Adapter plates should be attached to the output cables and
interface before the interface is installed in a rack or in
furniture. The screws for installing the adapter plates are
built into the plates, so no additional screws will be needed.
Adapter plate installation must be performed by
authorized service personnel only.
Follow these steps to install adapter plates. The RGB 138xi
is shown for illustration, but the steps apply to both models.
1. Make sure that the power is removed from the interface
by disconnecting the AC power cord from the unit.
2. Open the cover of the interface (the top half of the
enclosure), as shown below. Remove the screws
from the enclosure, and lift the cover straight up.
Do not touch any switches or electronic
components inside the interface. Doing so
could damage the interface.
RGB 138xi
R
G
B
1
3
8
x
i
IN
P
U
TS
A
U
D
IO
A
N
A
L
O
G
U
N
S
W
IT
C
H
E
D
6
0
0
W
A
T
T
S M
A
X.
M
I
N
/
M
A
X
M
B
C
P
O
W
E
R
U
N
IV
E
R
S
A
L
IN
T
E
R
FA
C
E
W
/A
D
S
P
Remove #8 Screws
(4 Places) Each Side
and Bracket, if Present
Remove (12)
Screws
Lift Cover
Straight Up
Opening the interface cover
3. Remove the blank plates from the interface by
unscrewing the nuts that fasten the plates to the
inside of the enclosure.
4. Route the adapter output cables through the rear panel
cable holes and clamps into the enclosure and out
the front panel plate openings, as shown on the
facing page.
5. Attach the output cables to the rear connectors of the
adapter plates. Soldering will be required for some
connectors.