Filter
Top Products
www.extron.com
© 2008 Extron Electronics. All rights reserved.
Pricing and specifications may change without notice.
USA West
+1.714.491.1500 / +800.633.9876
+1.714.491.1517 FAX
USA East
+1.919.863.1794 / +800.633.9876
+1.919.863.1797 FAX
China
+86.21.3760.1568 / +400.883.1568
+86.21.3760.1566 FAX
Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Europe
+31.33.453.4040 / +800.3987.6673
+31.33.453.4050 FAX
Dubai
+971.4.2991800
+971.4.2991880 FAX
Asia
+65.6383.4400 / +800.7339.8766
+65.6383.4664 FAX
www.extron.com
© 2008 Extron Electronics. All rights reserved.
Pricing and specifications may change without notice.
USA West
+1.714.491.1500 / +800.633.9876
+1.714.491.1517 FAX
USA East
+1.919.863.1794 / +800.633.9876
+1.919.863.1797 FAX
China
+86.21.3760.1568 / +400.883.1568
+86.21.3760.1566 FAX
Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Europe
+31.33.453.4040 / +800.3987.6673
+31.33.453.4050 FAX
Dubai
+971.4.2991800
+971.4.2991880 FAX
Asia
+65.6383.4400 / +800.7339.8766
+65.6383.4664 FAX
SW MTP T 15HD A Series
M TP - M in i Twi sT ed Pa ir se ri es
sPeciFicATions
Video
Number / Signal type ........... 1 set of proprietary analog signals
Connectors ....................... 1 female RJ-45
Video inPuT
Number / Signal type ........... 2, 4, or 6 (depending on the model) analog VGA-UXGA RGBHV, RGBS, RGsB,
component video, S-Video or composite video
Connectors ....................... 2, 4, or 6 (depending on the model) female 15-pin HD
Nominal level .................... 1 Vp-p for Y of component video and S-video, and for composite video
0.7V p-p for RGB and for R-Y and B-Y of component video
0.3V p-p for C of S-video
Minimum / Maximum levels ... Analog: 0.3 V to 1 Vp-p with no offset
Impedance ........................ 75 ohms
Horizontal frequency............ 15 kHz to 130 kHz
Vertical frequency ............... 30 Hz to 150 Hz
Return loss ....................... <-30 dB @ 5 MHz
DC offset (max. allowable) ....... 2 V
Video ouTPuT REFER TO TWISTED PAIR RECEIVERS’ SPECIFICATIONS AND MANUALS
sync
Input type ......................... RGBHV, RGBS, RGsB
Standards ......................... NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level ........................ 2.5 V to 5.5 V
Input impedance ................ 560 ohms
Max input voltage ............... 5.5 V
Audio
Number / Signal type ........... 1 set of proprietary analog signals
Connectors ....................... 1 female RJ-45
Gain ................................ 0 dB (unbalanced), +6 dB (balanced)
Frequency response ............ 20 Hz to 20 kHz, ±1 dB
THD + Noise ...................... 0.01% @ 1 kHz, 0.03% @ 20 kHz
S/N ................................. >75 dB at maximum output, unweighted
Crosstalk .......................... <-70 dB,@ 20 Hz to 20 kHz, +4 dBu stereo output
Stereo channel separation .... >62 dB @ 20 Hz to 20 kHz
CMRR .............................. >43 dB @ 20 Hz to 20 kHz
Audio inPuT
Number / Signal type ........... 2, 4, or 6 (depending on the model) stereo, unbalanced
Connectors ....................... 2, 4, or 6 (depending on the model) 3.5 mm mini audio jacks (tip, ring, sleeve)
Impedance ........................ >10k ohms unbalanced
Nominal level .................... -10 dBV (316 mVrms)
Maximum level .................. +15 dBV, unbalanced, at <1% THD+N
NOTE: 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
Audio ouTPuT
Number / Signal type ........... 1 set of proprietary analog signals to be sent to an MTP receiver
1 stereo, balanced/unbalanced
Connectors ....................... 1 female RJ-45 (for proprietary signals)
(1) 3.5 mm captive screw connector, 5 pole
Impedance ........................ 50 ohms unbalanced, 100 ohms balanced (for the stereo output)
Gain error ......................... ±1 dB channel to channel (for stereo output)
Maximum level (Hi-Z) ........... >+23 dBu, balanced, at <1% THD+N (for stereo output)
Maximum level (600 ohm) ..... >+17 dBu, balanced at <1% THD+N (for stereo output)
Stereo channel separation .... >60 dB @ 1 kHz
conTrol / reMoTe
—
swiTcher / TrAnsMiTTer
Serial control port ............... RS-232, 9-pin female D connector (shared with contact closure)
Baud rate and protocol ......... 9600 baud, 8 data bits, 1 stop bit, no parity
Serial control pin
configurations ................... 2 = TX, 3 = RX, 5 = GND
Contact closure .................. RS-232, 9-pin female D connector (shared with serial control)
Contact closure pin
configurations ................... 1 = input 1, 4 = input 2, 5 = GND, 6 = input 3, 7 = input 4, 8 = input 5,
9 = input 6
Program control ................. Extron’s control/configuration program for Windows
®
Extron’s Simple Instruction Set (SIS
™
)
GenerAl
Power .............................. Supplied by an external power supply
NOTE: The SW MTP Series transmitters cannot supply remote power to or receive remote power from attached receivers.
External power supply ......... 100 VAC to 240 VAC, 50/60 Hz, external, to 12 VDC, 2 A, regulated
Power input requirements ..... 12 VDC, 0.6 A
Temperature / Humidity ........ Storage -40° to +158°F (-40° to +70°C) / 10% to 90%, noncondensing
Operating +32° to +122°F (0° to +50°C) / 10% to 90%, noncondensing
Cooling ............................ Convection, unvented
Rack mount ...................... Yes, with optional 1U, 9.5” deep rack shelf, part #60-190-01 or 60-604-01; or
VersaTools
®
3” deep rack shelf, part #60-190-20 or 60-604-20.
Also furniture
Enclosure type ................... Metal
Enclosure dimensions .......... 1.75" H x 8.75" W x 3.0" D (1U high, half rack wide)
4.4 cm H x 22.2 cm W x 7.6 cm D
(Depth excludes connectors and toggle switch.)
Product weight .................. 0.8 lbs (0.4 kg)
Shipping weight ................. 3 lbs (2 kg)
Vibration .......................... ISTA 1A in carton (International Safe Transit Association)
Listings ............................ UL, CUL
Compliances ..................... CE, FCC Class A, VCCI, AS/NZS, ICES
MTBF .............................. 30,000 hours
Warranty .......................... 3 years parts and labor
NOTE: All nominal levels are at ±10%. Specifications are subject to change without notice.
94