Filter
Top Products
Extron • System 8/10 P
LUS
• User’s Manual • P/N 68-412-01 Rev. A
Hughes Installation Configuration and Connections
Page 1
Hughes-JVC DILA Projector Configuration (RS-232)
Verify that the System 8/10 Plus is already configured for the Hughes-JVC DILA
G1000/G10 projector by following the procedure and switch settings below. The
general setup is explained on page 3-4 of your System 8/10 Plus User’s Manual.
1. Use a small screwdriver to remove the access cover from the System 8/10 Plus
front panel. Refer to page 3-3 of the User’s Manual.
_______________ Before changing anything, remove the AC power cord to the System 8/10 Plus
and also turn the projector’s power OFF.
2. Set the System 8/10 Plus switches as follows:
Config Model Rotary Switches Cable SW15 Settings Comm
as RS1 RS2 RS3 RS4 J2/J3 1 2 3 4 5 6 7 8 9 10 Adapter
4
Hughes-JVC DILA 0 0 F 8 J2 ↓↓ ↑ ↓ ↑↓ ↓ ↓
¯
↑↓ 26-467-01
3. Locate the switcher’s Address DIP switches on the rear panel, lower right.
Unless this is part of a master/slave system, set #3 and #5 to the up position and
the others in the down position. See illustration on the left.
4. Use the illustration on the following page and continue with the steps below.
5. Connect the BNC cables from the System 8/10 Plus outputs to the projector
inputs according to the application requirements (RGBS, S-Video or Composite
Video).
6. Apply Main Power to the System 8/10 Plus by connecting the power cord. The
Main Power LED should light. Apply power to the projector.
7. Installation is now completed.
Configured For:
RS-232
3456789101
2
SW15 DIP Switch
ON
RS5 RS2
RS2
RS1
RS3
RS4
RS1
RS3 RS4