Extron electronic VNR 100 Network Router User Manual


  Open as PDF
of 4
 
1
VNR 100 • Setup Guide
The Extron VNR 100 recorder is a network storage device capable of recording and playing back PURE3 video, audio, and
data streams from VN‑Matrix codecs and encoders in a VN‑Matrix system. The system must be under the control of an Extron
VNMEnterprise Controller.
This guide provides basic instructions for an experienced installer to congure and operate a VNR 100 recorder.
NOTE: For complete instructions about mounting, installation, and network conguration, see the VNR 100 User Guide and
the VNM Enterprise Controller User Guide at www.extron.com.
VN-Matrix
VNR 100
Recorder
VN-Matrix
VNR 100
Recorder
Network
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
LAN-1
LAN-2
STATUS
VN-MATRIX 225 SERIES
RGB/DVI OVER IP
LAN-1
LAN-2
STATUS
Browser Based User
Control
Multicast Enabled
Network
Multiple VNM 200 and 225 Series Encoders
(or CODECs configured as encoders)
VNM Enterprise Controller
TouchLink
™
Touchpanel
External User Control
Multiple VNM 200 and 225 Series Decoders
(or CODECs configured as decoders)
VNR 100 Recorder
VNR 100 Recorder
Installation
1. Mount the VNR 100 using the provided rack mount kit (see Mounting, below).
2. Connect a standard IEC power cord to the rear panel connector (see Rear Panel Features on page 2).
3. Connect the VNR 100 to the same network as the VNM Enterprise Controller, using Ethernet port 0 (see Rear Panel Features
on page 2).
4. Power on the VNR 100 (see VNR 100 Power Up Procedure on page 3).
5. Use a computer on the same network to carry out the initial conguration (see VNR 100 Initial Configuration on page 3).
6. Use the VNM Enterprise Controller to congure the VNR 100 (see Getting Started with the VNM Enterprise Controller on
page 4).
7. If it becomes necessary to power down the VNR 100, see VNR 100 Power Down Procedure on page 3.
Mounting
The VNR 100 can be mounted in a rack, using the provided kit. See the VNR 100 User Guide at www.extron.com for UL
guidelines for rack mounting and complete mounting instructions.
next