Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 6.0)
3
Adjusting for the Resin Dither _______________________________________________________138
Using the Print Both Sides option (DTC520/DTC525 only) ________________________________139
Using the Split 1 Set of Ribbon Panels option (DTC520/DTC525 only)_______________________140
Using the Print Back Side First option _________________________________________________141
Using the Print on Back Side Only option (DTC520/DTC525 only)__________________________142
Using the Rotate Front by 180 Degrees option___________________________________________143
Using the Rotate Back by 180 Degrees option (DTC520/DTC525 only)_______________________144
Using the Buffer Single Card option __________________________________________________145
Using the Link Card to Print Job option________________________________________________146
Using the Disable Printing option_____________________________________________________147
Using the Image Color tab_____________________________________________________________148
Using the K Panel Resin tab ___________________________________________________________152
Selecting the Full Card with the K Panel Resin tab _______________________________________153
Selecting the Defined Area(s) with the K Panel Resin tab __________________________________154
Selecting the Undefined Area(s) with the K Panel Resin tab ________________________________155
Defining the Area to activate the Card Grid_____________________________________________156
Measuring the Total Card area _______________________________________________________157
Defining the positioning of the area on the Card _________________________________________159
Selecting the Print YMC under the K and Print K Only options _____________________________161
Using the Magnetic Encoding tab _______________________________________________________163
Using the Encoding Mode option_____________________________________________________164
Encoding the Mode/Coercivity/Magnetic Track Selection__________________________________166
Using the Magnetic Track Selection option _____________________________________________168
Reviewing the Enable MLE Support checkbox __________________________________________169
Using the Magnetic Track options ____________________________________________________170
Using the Bit Density radio buttons ___________________________________________________171
Using the Character Size radio buttons_________________________________________________171
Using the ASCII Offset ____________________________________________________________172
Using the LRC Generation radio buttons _______________________________________________173
Using the Character Parity radio buttons _______________________________________________173
Using the Verification option ________________________________________________________174
Reviewing the Shift Data Left _______________________________________________________175
Reviewing the ISO Track Locations___________________________________________________176
Reviewing the Sample String ________________________________________________________176
Sending the Track Information_______________________________________________________177
Reviewing the ASCII Code and Character Table_________________________________________178
Using the Overlay/Print Area tab _______________________________________________________179
Using the Overlay/Print Area dropdown menu __________________________________________180
Using the Overlay/Print Area ________________________________________________________181
Using Security Options (Visual Security Solutions)_______________________________________187
Selecting Orientation - Landscape under Card tab ________________________________________188
Selecting the Visual Security Solutions dropdown menu (A to D) ___________________________189
Selecting Orientation - Portfolio under Card tab _________________________________________190
Selecting the Visual Security Solutions dropdown menu (E to H)____________________________191
Selecting the VeriMark radio button __________________________________________________192
Selecting the HoloMark radio button __________________________________________________193
Reviewing the Custom VeriMark Card ________________________________________________194
Reviewing the Custom HoloMark Card ________________________________________________195
Using SmartShield Area dropdown menu ______________________________________________196
Using the Card tab___________________________________________________________________197
Selecting the Card Size_____________________________________________________________198
Using the Card Hopper Selection (DTC515/DTC525 only) option ___________________________200
Reviewing the Orientation __________________________________________________________203
Specifying the Copies______________________________________________________________203
Using the Test Print button__________________________________________________________204
Clicking on the About button ________________________________________________________205