Fellowes 200C/130C Paper Shredder User Manual


  Open as PDF
of 6
 
4
TROUBLESHOOTING
OverheatIndicator:WhentheOverheatIndicatorisilluminated,theshredderhasexceededitsmaximumoperatingtemperatureandneedstocooldown.Thisindicator
will remain illuminated and the shredder will not operate for the duration of the recovery time.
BinOpen:Theshredderwillnotrunifthebinisopen.Whenilluminated,closethebintoresumeshredding.
RemovePaper:Whenilluminated,pressreverse( );openlidandremovepaper.
BinFull:Whenilluminated,theshredderwastebinisfullandneedstobeemptied.UseFelloweswastebag36053.
PRODUCT MAINTENANCE
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
Paperdetectionsensorsaredesignedformaintenancefreeoperation.However,onrareoccasionsthesensors
may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: the paper detection sensors is located in the center of the paper entry).
Allcross-cutshreddersrequireoilforpeakperformance.Ifnotoiled,a
machinemayexperiencediminishedsheetcapacity,intrusivenoisewhen
shredding,andcouldultimatelystoprunning.Toavoidtheseproblems,we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
15
15
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Turnoffandunplug
shredder
*Carefully apply oil
across cutters (do not
get oil in paper tray)
Close lid. Press and
hold forward (
)
2-3 seconds
Open lid
Locate Auto-start
infrared sensor
Usingcottonswab,
wipe away any
contamination from
the paper sensors
Dip cotton swab in
rubbing alcohol
4
Open lid
1
3 1
2 53
ADVANCED PRODUCT FEATURES
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
SilentShred™
Technology
SilentShred™noisequality
shreds without noisy disruptions.
Energy Saving Sleep Mode
Feature shuts down the shredder
after 2 minutes of inactivity
WHEN IN SLEEP MODE
Togetoutofsleepmode,
open lid and load paper
Insert paperor
SLEEP MODE OPERATION
Feature shuts down the shredder after 2 minutes
of inactivity
2
1
2
* Shredder will not run when lid is open.
MISALIGNED PAPER
If paper is not shredding
throughautofeedtray,
check position of paper.
Paper should be flat and
aligned with front of
paper tray.
1 2
 previous next