LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. Fellowes warrants all other parts of the machine to be free of defects in material and
workmanship for 1 year from the date of purchase by the original consumer. If any part is found to
be defective during the warranty period, your sole and exclusive remedy will be repair or replacement,
at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE,
IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE.
In no event shall Fellowes be liable for any consequential or incidental damages attributable to
this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty
are valid worldwide, except where different limitations, restrictions, or conditions may be required
by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
Continuous
operation:
5 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4-5 minutes will trigger
20-minute cool down period.
Pull uncut paper from
paper entry
Press and hold
Reverse (R)
Set to Off Press and hold
Reverse (R)
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
OPERATION
TROUBLESHOOTING
MAINTENANCE
3
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/
3505006
15
Shredder doesn’t start:
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Make sure control switch is in Auto-On
( ) position
Clear paper particles covering magnetic
safety interlock
Wait 20 minutes for red light to turn off
Follow oiling procedure below and repeat twice.
ATTENTION: If the SafeSense
®
light remains on, you must engage the
Override Switch in order to perform steps above. Once the jam is cleared, reset the
SafeSense
®
feature. (See SafeSense
®
instructions below.)
WARRANTY
Alternate slowly back and forth
*Apply oil
across entry
Press and hold
Reverse (R)
2-3 seconds
Shred one sheet
Set to Off Press Auto-On ( )
Press Auto-On ( )
Hold credit card
at edge
Feed into card entry
and release
PAPER
Set to Off
Feed into paper entry
and release
SafeSense
®
override switch
Active Not active
Sensor light illuminated–paper
jammed
SafeSense
®
paper jam: If the SafeSense
®
feature activates (SafeSense
®
light remains on) to cause
the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the
SafeSense
®
feature and clear the paper. Warning – when switch is in override position, the SafeSense
®
light
will flash and the SafeSense
®
feature will NOT function. Once the paper is cleared, reset the SafeSense
®
feature.
CARD
Press Auto-On ( )
Set to Off
Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the below procedures.