Fellowes 3229901 Paper Shredder User Manual


  Open as PDF
of 6
 
ENGLISH
Model 99Ci
Press and hold forward ( )
2-3seconds
2
PRODUCT MAINTENANCE
TROUBLESHOOTING
CLEANING AUTO-START INFRARED SENSORS
Paperdetectionsensorsaredesignedformaintenancefreeoperation.However,onrareoccasionsthesensors
maybecomeblockedbypaperdustcausingthemotortorunevenifthereisnopaperpresent.
(Note:twopaperdetectionsensorsarelocatedinthecenterofthepaperentry).
Allcross-cutshreddersrequireoilforpeakperformance.Ifnotoiled,a
machinemayexperiencediminishedsheetcapacity,intrusivenoisewhen
shreddingandcouldultimatelystoprunning.Toavoidtheseproblems,we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
15
*Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
17
1
TO CLEAN THE SENSORS
1
Turn off and unplug
shredder
LocateAuto-start
infared sensor
Dip cotton swab in
rubbing alcohol
Usingcottonswab,wipe
away any contamination
from the paper sensors
17
43
17
2
17
17
Should you choose to disable the
system,pressandholdtheauto
button (blue) and reverse ( )
keyatthesametime
DISABLING THE FEATURE
Oncedisabled,theblue
Auto light is no longer
illuminated(Tore-engage,
repeat step 1)
Shredding can continue with the
systemdisabled,howeverapaper
jammayoccurwithtoomanysheets
and Remove Paper icon
( )
will illuminate
If steps 4 and 5 do not clear
jam,reversepaperalltheway
out,removeseveralsheets
and refeed
6
17
1
AUTO
AUTO
2
Ifjamoccurs,pressandhold
forward()keyuntilthe
document is completely through
the shredder
3
Ifnotcleared,pressreverse
( ) briefly (repeat steps
4 and 5 until shredded)
Eliminates paper jams and powers through tough jobs
JAM PROOF SYSTEM*
*100%JamProofwhenusedinaccordancewithusermanual
5
3
4
5
3
5
A B C D E
A. Overheat Indicator: WhentheOverheatIndicatorisilluminated,theshredderhasexceededitsmaximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information about
the continuous operation and recovery time for this shredder.
B. Bin Open: The shredder will not run if the bin is open.
Whenilluminated,closethebintoresumeshredding.
C. Bin Full:Whenilluminated,theshredderwastebinisfullandneedstobeemptied.
Use Fellowes waste bag 36053.
D. Remove Paper:Whenilluminated,pressreverse(
) and remove paper.
Reducepaperquantitytoanacceptableamountandrefeedintopaperentry.
E. SafeSense
®
Indicator:Ifhandsaretooclosetothepaperentry,theSafeSense
®
indicator will illuminate
and the shredder will stop shredding. If SafeSense
®
isactivefor3seconds,theshredderwillautomatically
turn off and the user must press the power button on the control panel to resume shredding.
 previous next