Fellowes 325Ci Paper Shredder User Manual


  Open as PDF
of 8
 
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
CLEANING AUTO-START INFRARED SENSORS
PRODUCT MAINTENANCE
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
/PUFUXPQBQFSEFUFDUJPOTFOTPSTBSFMPDBUFEJOUIFDFOUFSPGUIFQBQFSFOUSZ.
TO CLEAN THE SENSORS
ENGLISH
Models 325Ci/325i
"MMDSPTTDVUTISFEEFSTSFRVJSFPJMGPSQFBLQFSGPSNBODF*GOPUPJMFEBNBDIJOFNBZFYQFSJFODFEJNJOJTIFETIFFUDBQBDJUZJOUSVTJWF
OPJTFXIFOTISFEEJOHBOEDPVMEVMUJNBUFMZTUPQSVOOJOH5PBWPJEUIFTFQSPCMFNTXFSFDPNNFOEZPVPJMZPVSTISFEEFSFBDIUJNFZPV
empty your waste bin.
OILING SHREDDER
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
4
Press and hold forward
( ) 2-3 seconds
2
3
5VSOPGGBOEVOQMVH
shredder
Locate Auto-start
infrared sensor
6TJOHDPUUPOTXBCXJQF
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
1
2 4
1
Straight Feed Indicator: When illuminated, remove paper and feed straight into paper entry.
#JO'VMM*OEJDBUPS8IFOJMMVNJOBUFEUIFTISFEEFSXBTUFCJOJTGVMMBOEOFFETUPCFFNQUJFE6TF'FMMPXFTXBTUFCBH
%PPS0QFO*OEJDBUPS5IFTISFEEFSXJMMOPUSVOJGUIFDBCJOFUEPPSJTPQFO8IFOJMMVNJOBUFEDMPTFUIFEPPSUPSFTVNFTISFEEJOH
Remove Paper Indicator: When illuminated, press reverse ( BOESFNPWFQBQFS3FEVDFQBQFSRVBOUJUZUPBOBDDFQUBCMFBNPVOUBOESFGFFEJOUPQBQFSFOUSZ
SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
®
indicator will illuminate and the shredder will stop shredding. If SafeSense
®
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
 previous next