Filter
Top Products
3
1. Ensure the machine is on a
stable surface.
2. Check waste tray is empty
and correctly fitted.
3. Lift the lid. Ensure the wire
closing lever is pushed backwards.
4. Lift the punch handle to its
upright position.
BEFORE YOU BIND
1. Select the correct wire comb
diameter using the comb
storage tray.
2. Hang the selected wire
comb onto wire comb support.
STEPS TO BIND
1
21 3
4. Lift the wire comb upwards off the
hooks. Carefully place into the open
wire closing mechanism. Ensure the
wire comb is open and touching the
bottom of the mechanism.
5. Lift the wire closing lever
forwards. The closing scale guide is
on the moving jaw. Close the jaws
until the wire gauge shows the size
of wire being closed.
6. Check the closed seam. If
the seam is not closed correctly,
the document can be placed
into the jaws and closed again.
7. To hide the seam, turn the
rear cover backwards. The front
cover is now visible. The seam is
hidden inside the document.
6 7
3. Test punch scrap sheets to
check edge guide setting.
3
SET UP
4
2
5
4
1. Punch sheets in small
batches that do not overload
the machine or user.
2. Starting with the rear cover.
Load punched sheets directly onto
the hanging open wire comb.
3. Punch and hang the front
cover. Punch and hang the
remaining sheets.
1 3
30
Max 15
(80gsm)
2
8. Check wire seam closure is
complete. Loose binding allows
sheet loss. Good closure retains
all sheets.
8