Filter
Top Products
ENGLISH
5
Maintenance
Regular emptying of the basket
is important to ensure the smooth operation of the
cutting cylinders. If you can see paper in the basket window (7), turn off the shredder, pull
out the basket and empty basket contents.
Regular oiling of the shredder
is also necessary to ensure proper performance. If you
are running the shredder at or near capacity, we recommend oiling it monthly. Using
Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable-based oil in a
long-nozzle container:
• Apply oil over full width of paper entry (1) with shredder in off [O] position.
• Press control switch to automatic [I] position which will cause shredder to run
for about 2 seconds.
• Press and hold control switch in reverse [R] position for 3-5 seconds.
• Repeat above automatic [I] and reverse [R] sequence three times.
REMINDER:
Do not use flammable synthetic oil, petroleum-based products or aerosol
lubricants of any kind in or near the shredder at any time.
Troubleshooting
If you have a problem with your shredder, check the symptoms and remedies below. If you
cannot solve the problem this way, contact Fellowes Customer Service.
Do not open
shredder head
to attempt repair: It could expose you to serious electric shock and will
void your warranty.
Symptom
Shredder does not start or stops while
shredding.
Overheat light (9) turns on and shredder
will not operate.
Red display light (10) turns on and shred-
der will not operate.
Shredder squeaks, grinds or runs below
capacity.
Shredder continues to run for a few sec-
onds after shredding has been completed.
Remedy
• Make sure shredder is plugged in and
switch is in automatic [I] position.
• If paper appears to be jammed. Follow
instructions under Operation.
• Check basket position; basket must be
pushed all the way in the cabinet.
Follow instructions under Set-Up.
•Wait 30 minutes for shredder to cool
down before trying again.
• If paper appears to be jammed. Follow
instructions under Operation.
• Check basket position; basket must
be pushed all the way in the cabinet.
Follow instructions under Set-Up.
• Oil cutting cylinders. Follow instructions
under Maintenance.
• No action required. This is a self-clean-
ing function.