2
KEY
CAPABILITIES
ENGLISH
Model DS-12Cs
Will shred: Paper, small paper clips, credit cards and staples
Will not shred: Continuous forms, CD/DVDs, adhesive labels, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic
other than noted above
Paper shred size:
Cross-Cut ........................................................5/32 in. x 2 in. (3.9mm x 50mm)
Maximum:
Sheets per pass .................................................................................................12*
Cards per pass .....................................................................................................1*
Paper width ......................................................................................9 in. (229mm)
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 5.0Amps; heavier paper, humidity or
other than rated voltage may reduce capacity. Recommended daily usage rates: 120 sheets;
10 credit cards.
12 sheets per pass.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
H. Control switch and LEDs
I 1. Auto-On
O 2. OFF
R 3. Reverse
4. Standby (green)
5. SafeSense
®
Technology
(yellow)
6. Overheat (red)
A. Shredder head
B. Paper/credit card entry
C. Pull-out bin
D. Window
E. Safety Lock
F. Disconnect power switch
1. OFF
2. ON
G. See safety instructions
2
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
15
15
• Keepawayfromchildrenandpets.Keephandsawayfrompaperentry.Always
set to off or unplug when not in use.
• Keepforeignobjects–gloves,jewelry,clothing,hair,etc.–awayfromshredder
openings. If object enters top opening, switch to Reverse (R) to back out object.
• Neveruseaerosolproducts,petroleumbasedlubricantsorotherflammable
products on or near shredder. Do not use canned air on shredder.
• Donotuseifdamagedordefective.Donotdisassembleshredder.
Do not place near or over heat source or water.
• Operation,maintenance,andservicerequirementsarecoveredintheinstruction
manual. Read the entire instruction manual before operating shredders.
• ThisshredderhasaDisconnectPowerSwitch(F)thatmustbeintheON(
–
)
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
• Avoidtouchingexposedcuttingbladesundershredderhead.
• Shreddermustbepluggedintoaproperlygroundedwalloutletorsocketofthe
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIREHAZARD–DoNOTshredgreetingcardswithsoundchipsorbatteries.
• Forindooruseonly.
• Unplugshredderbeforecleaningorservicing.
15
15
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
•Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
•Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
A.
G.
B.
H.
F
D.
C.
E.