Filter
Top Products
3
BASIC SHREDDING OPERATION
ADVANCED PRODUCT FEATURES
SAFESENSE
®
TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
Turn the shredder
ON (
)to activate
SafeSense
®
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active
and working properly
3
10
HD-10c
s
2
Continuous operation:
6QUP
5-minute maximum
NOTE: Shredder runs briefly after each pass
to clear entry. Continuous operation beyond
5-minutes will trigger 20-minute cool
down period.
1
PAPER/CARD
Plug in and put disconnect
power switch in ON (I) position
Feed paper/card
straight into paper
entry and release
When finished shredding,
set to Off
2
4
Press Auto-On ( )
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
HD-10
"MMDSPTTDVUTISFEEFSTSFRVJSFPJMGPSQFBLQFSGPSNBODF*GOPUPJMFEB
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entrySet to Off (O)
Press and hold Reverse
(R) 2-3 seconds
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry).
* Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TO CLEAN THE SENSORS
Locate Auto-start
infrared sensor
6TJOHDPUUPOTXBCXJQF
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
Set to Off (O)
and unplug
3
1
1 2 3
HD-10C
s
4
TROUBLESHOOTING
Alternate slowly back and forthPress and hold
Reverse (R)
2-3 seconds
Set to Off
and unplug
Gently pull uncut
paper from paper
entry. Plug in
Shredder doesn’t start:
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Wait 20 minutes for motor to cool down
Make sure head is on basket correctly
Remove and empty basket
PAPER JAM
Set to Auto-On ( )
and resume shredding
1
4
3
2
6
HD-10C
s
5
HD-10C
s
2
HD-10C
s
3
1
ATTENTION: If the SafeSense
®
light remains on, you must engage the
Override Switch in order to perform steps above.
Once the jam is cleared, reset the SafeSense
®
feature. (See SafeSense
®
instructions below.)