Filter
Top Products
ENGLISH
Models P-40/P-45C
CAPABILITIES
Will shred: Paper, credit cards and staples
Will not shred: Continuous forms, adhesive labels, transparencies,
newspaper, cardboard, paper clips, laminates or plastic other than
noted above
Paper shred size:
Strip-Cut ............................................................................1/4” (6.3mm)
Confetti-Cut .....................................................5/32” x 2” (3.9 x 50mm)
Maximum:
Sheets per pass (Strip-Cut P-40) ............................................................8*
Sheets per pass (Confetti-Cut P-45C) .....................................................6*
Cards per pass ........................................................................................1
Paper width .............................................................................9”/229mm
Continuous operation ..............................................................5-7 minutes
* 20lb., 8.5”x11” paper at 120v, 60Hz, 2.0 Amps; heavier paper, humidity or
other than rated voltage may reduce capacity.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Always unplug or set
safety lock when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc.– away from shredder openings. If object enters top
opening, switch to Reverse (R) to back out object.
• Never use aerosol, petroleum-based or other flammable products
on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not open shredder head.
Do not place near or over heat or water source.
• 6 sheets per pass to avoid jams
• Avoid touching exposed blades under Confetti-Cut shredder head.
• The socket-outlet shall be installed near the quipment and shall be
easily accessible.
2
Handle
Control switch
Sheet capacity gauge
Pivoting head
Bin
Easy emptying
Shredder head
Auto-On (I)
Off (O)
Reverse (R)
Safety flap
(Cross-Cut models only)
To set lock, push
down and slide
Safety lock
Paper/credit card entry
See safety instructions below
Unlocked (green)
Locked (red)
Waste opening
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or
all of the below procedures.
OPERATION
TROUBLESHOOTING
Check paper amount
Set to Off (O)
and plug in
Set to Off (O)
and unplug
Set to Auto-On (I)
Set to Auto-On (I)
Feed into paper entry
and release
Hold card at edge
Feed into center of entry
and release
Continuous operation:
5-7 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond 5-7
minutes will trigger 20-minute
cool down period.
*Apply oil
across entry
Set to Auto-On (I)
Set to Off (O)
*Only use a non-aerosol vegetable oil in long nozzle container
Shred one sheet
Confetti-Cut and Strip-Cut:
Run regularly in reverse for
one minute
Confetti-Cut only:
Lubricate when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
Insert waste bag (Fellowes #36052) for easy disposal.
Shredder doesn’t start:
Alternate slowly back and forthSet to Reverse
(R) for 2-3
seconds
Set to Off (O)
and unplug
PAPER
CARD
Make sure head is on basket correctly
Wait 20 minutes for motor to cool down
Remove and empty basket
Make sure safety lock is in unlock
(green) position
WARRANTY
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the
machine to be free from defects in material and workmanship for 3 years from
the date of purchase by the original consumer. Fellowes warrants all other parts
of the machine to be free of defects in material and workmanship for 1 year from
the date of purchase by the original consumer. If any part is found to be defective
during the warranty period, your sole and exclusive remedy will be repair or
replacement, at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized
repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE
APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be
liable for any consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of
this warranty are valid worldwide, except where different limitations, restrictions,
or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or
your dealer.
MAINTENANCE
Follow oiling procedure below and repeat twice.
Remove shredder head
and cut hanging shreds.
Replace shredder head.
Plug in.
Set to
Reverse (R)
3
Set to Reverse (R)
for 2-3 seconds
Safety Lock prevents accidental operation. To set, wait for shredding to stop, push black button down and slide until you see red.
To unlock push black button down and slide until you see green. For greater safety, always unplug shredder after use.
P40_P45C.401207D.Eng.031506.indd2-3 2-3P40_P45C.401207D.Eng.031506.indd2-3 2-3 3/15/06 1:02:05 PM3/15/06 1:02:05 PM