Fellowes PS-14Cs Paper Shredder User Manual


 
PS-14Cs
ENGLISH
Model PS-14Cs
Indicator lights (red)
Paper Jam
Door Open
Overheated
Will shred: Paper, credit cards, CD/DVD’s, staples and small paper clips
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,
cardboard, large paper clips, laminates or plastic other than noted above
Paper shred size:
Cross-Cut .....................................5/32 inches x 1-1/2 inches (3.9mm x 38mm)
Maximum:
Sheets per pass (Cross-Cut) ............................................................................. 14*
Cards/CDs per pass .......................................................................................... 1*
Paper width ................................................................................9 inches/229mm
Continuous operation ......................................................................10-12 minutes
* 20lb., 8.5 inches x 11 inches (75g) paper at 120v, 60 Hz, 4.0Amps; heavier paper,
humidity or other than rated voltage may reduce capacity. Recommended daily usage
rates: 25-50 paper passes; 25 cards; 10 CDs.
• Avoid touching exposed blades under Cross-Cut shredder head.
• Use only designated entry for cards/CDs. Keep finger away from
CD hole.
The grounded socket-outlet shall be installed near the equipment
and shall be easily accessible.
2
Keep away from children and pets. Keep hands away
from paper entry. Always set to off or unplug when
not in use.
Keep foreign objects – gloves, jewelry, clothing, hair,
etc. – away from shredder openings. If object enters
top opening, switch to Reverse (R) to back out object.
Never use aerosol, petroleum based or other flammable products
on or near shredder. Do not use canned air on shredder.
Do not use if damaged or defective. Do not open shredder head.
Do not place near or over heat or water source.
14 sheets per pass to avoid jams.
— To Test SafeSense
®
Technology
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
CAPABILITIES
15
15
15
1 5
1 5
Breakthrough Safety Technology! SafeSense
®
stops shredding when hands are too close to the opening.
SET UP
Sensor lights up
Press Auto-On ( I )
Control switch
Auto-On (I)
Off (O)
Reverse (R)
SafeSense
®
(yellow)
Standby (green)
SafeSense
®
override switch
See safety instructions below
Card/CD entry
Window
Shredder head
Sheet capacity gauge
Sheet capacity icon
Paper entry
SafeSense
®
Technology
Disconnect Power Switch
must be in ON position to
operate shredder.
Insert waste bag (Fellowes
#36052) for easy disposal.
A B
Active Not active
Touch test area
Pull-out bin
Disconnect power switch
Continuous operation:
10-12 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
10-12 minutes will trigger
20-minute cool down period.
15
Paper jam: Set to Off (O) and empty bin. Replace bin, close door and follow any or all of the below procedures.
Gently pull uncut paper
from paper entry. Plug in.
Press and hold
Reverse (R)
Set to Off (O)
and unplug
Press and hold
Reverse (R)
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
OPERATION
TROUBLESHOOTING
MAINTENANCE
3
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
15
Indicator lights:
Yellow - SafeSense
®
active
Yellow flashing - SafeSense
®
not active
Make sure bin is pushed in
Wait 20 minutes for motor to cool down
Follow oiling procedure below and repeat twice.
ATTENTION: If the SafeSense
®
light remains on, you must engage the
Override Switch in order to perform steps above. Once the jam is cleared, reset the
SafeSense
®
feature. (See SafeSense
®
instructions below.)
WARRANTY
Alternate slowly back and forth
*Apply oil
across entry
Press and hold
Reverse (R)
2-3 seconds
Shred one sheet
Set to Off (O) Press Auto-On (I)
Press Auto-On (I)
Hold card/CD
at edge
Press Auto-On (I)
Feed into card/CD entry
and release
PAPER
CARD/CD
Set to Off (O)
and plug in
Set to Off (O)
and unplug
Feed into paper entry
and release
SafeSense
®
override switch
Active Not active
Sensor light illuminated–paper
jammed
Check paper amount
SafeSense
®
paper jam: If the SafeSense
®
feature activates (SafeSense
®
light remains on) to cause the user
to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense
®
feature and clear the paper. Warning – when switch is in override position, the SafeSense
®
light will flash and
the SafeSense
®
feature will NOT function. Once the paper is cleared, reset the SafeSense
®
feature.
PS-14C
PS-14C
PS-14C
PS-14C
PS-14C
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. Fellowes warrants all other parts of the machine to be free of defects in material and
workmanship for 1 year from the date of purchase by the original consumer. If any part is found to
be defective during the warranty period, your sole and exclusive remedy will be repair or replacement,
at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS
HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In
no event shall Fellowes be liable for any consequential or incidental damages attributable to this
product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty
are valid worldwide, except where different limitations, restrictions, or conditions may be required
by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.