Filter
Top Products
TROUBLESHOOTING
9
Problem Possible cause Solution
No ‘red’ power on LED Machine is not switched on
Switch on machine at rear next to plug
inlet and at the wall socket
Ready light does not come on after a
long period
Machine is in a hot or humid area
Move the machine to a cooler and
dry area
Pouch does not completely seal the item
Item may be too thick to laminate Pass through the machine again
Thickness setting may be incorrect
Check pouch thickness is correctly
selected and pass through again
Pouch has waves or bubbles Thickness setting may be incorrect
Check pouch thickness is correctly
selected and pass through again
Pouch is lost in the machine Pouch is jammed
Select reverse button and pull out the
item by hand. Select the open machine
setting and clean the rollers.
Jamming
Pouch was used ‘open end’ first
Pouch was not centered on entry
Pouch was not straight upon entry
Empty pouch was used
Pouch is damaged after lamination Damaged rollers or adhesive on rollers
Pass cleaning sheets (CRC# 53206)
through the machine to test and
clean rollers. Select the open machine
setting and clean the rollers with
Fellowes roller wipes (CRC# 57037).
Cannot open top cover to gain ‘Easy
Access’
Top cover locking screw is still located on the
left side of the machine
Remove the screw then open the lid
as advised.
Small pouch is lost in the machine
Pouch may be too small to use without a
carrier
Select ‘Easy Access’ and open the
machine. Remove the pouch and
laminate small pouches with a carrier
or on a sheet of paper.