FCLF-8520/8521-3 1000BASE-T SFP Product Specification Finisar
V. General Specifications
Notes:
General
Parameter Symbol Min Typ Max Units Notes/Conditions
Data Rate BR 10 1,000 Mb/sec IEEE 802.3 compatible.
See Notes 2 through 4 below
Cable Length L 100 m Category 5 UTP. BER <10
-12
Table 6. General specifications
1. Clock tolerance is +/- 50 ppm
2. By default, the FCLF-8520/8521-3 is a full duplex device in preferred master mode
3. Automatic crossover detection is enabled. External crossover cable is not required
4. 10/100/1000 BASE-T operation requires the host system to have an SGMII interface
with no clocks, and the module PHY to be configured per Application Note AN-2036.
With a SERDES that does not support SGMII, the module will operate at 1000BASE-T
only.
VI. Environmental Specifications
The FCLF-8520/8521-3 has an extended range from 0°C to +85°C case temperature as
specified in Table 8.
Environmental
Specifications
Parameter Symbol Min Typ Max Units Notes/Conditions
Operating Temperature T
op
0 85 °C Case temperature
Storage Temperature T
sto
-40 85 °C Ambient temperature
Table 7. Environmental specifications
VII. Serial Communication Protocol
All Finisar SFPs support the 2-wire serial communication protocol outlined in the SFP
MSA
1
. These SFPs use an Atmel AT24C01A 128 byte E
2
PROM with an address of A0h.
For details on interfacing with the E
2
PROM, see the Atmel data sheet titled
“AT24C01A/02/04/08/16 2-Wire Serial CMOS E
2
PROM.”
3
The 1000BASE-T physical layer IC can also be accessed via the 2-wire serial bus at
address ACh. For details interfacing with the PHY IC, see Marvell data sheet titled
“Alaska Ultra 88E1111 Integrated Gigabit Ethernet Transceiver”
4
(Marvell document
number MV-S100649-00).
© Finisar Corporation December 16, 2005 RevB Page 5