Finisar FTLX1341E2 Network Card User Manual


 
© Finisar Corporation – October 2008 Rev B Page 1
Product Specification
RoHS-6 Compliant
10GBASE-LRM X2 Transponder
FTLX1341E2
PRODUCT FEATURES
Hot pluggable X2 MSA form factor
Total power consumption: 4.0 W maximum
RoHS-6 compliant (lead-free)
Temperature range 0°C to 70°C
Transmission distance up to 220m
*
Uncooled 1310 nm directly modulated
Fabry-Perot (FP) laser
Built In Advanced Electronic Dispersion
Compensation (EDC)
SC connector, multimode fiber
Full duplex transmission mode
Digital Optics Monitoring (DOM)
Power supply: +5.0 V, +3.3 V
Adaptable Power Supply (APS: +1.2 V)
XAUI electrical interface
- 4 x 3.125 Gb/s Ethernet
Management and control via MDIO
2-wire bus
70-pin connector
Separated signal/chassis ground
Mid Pak module variance for
front panel mounting
De-latch mechanism with low
extraction force
APPLICATIONS
IEEE 802.3aq-2006
10 Gb/s Ethernet transmission on
legacy multimode fiber.
The Finisar FTLX1341E2 transponder incorporates Electronic Dispersion Compensation (EDC)
which provides correction for the severe modal dispersion that may occur during propagation
through links up to 220m on legacy installed FDDI multimode fiber. The EDC device
incorporates a Feed Forward Equalizer (FFE) and a Decision Feedback Equalizer (DFE). The
EDC also contains sophisticated clock recovery architecture for extracting a robust clock from
extremely distorted signals.
PRODUCT SELECTION
FTLX1341E2
* Maximum reach as defined by IEEE. Longer reach possible depending upon link implementation.