Filter
Top Products
No sound.
52
Problem:
Check Ceiling feature.
(See "OTHER FUNCTION SETTING" section on pages 46 ~ 47).
Picture is L/R Reversed.
Check Ceiling/Rear feature.
(See "OTHER FUNCTION SETTING" section on pages 46 ~ 47).
Picture is T/B inverted.
Check Display feature.
(See "OTHER FUNCTION SETTING" section on pages 46 ~ 47).
Some displays are not seen
during the operation.
● Check audio cable connection from audio input source.
● Adjust audio source.
● Press the VOLUME (+) button.
● Press the MUTE button.
● Check the batteries.
● Make sure nothing is blocking between the remote control sensor and
remote control unit.
● Make sure you are not too far from the projector when using the remote
control unit. Maximum operate range 16.4 ' (5 m).
● Check the ALL-OFF switch on the Remote Control Unit is set to "ON".
● Check the transmitted signal mode from the remote control unit.
(See "OTHER FUNCTION SETTING" section on pages 46 ~ 47).
Remote control unit does not
work.
● Check the cable connection between the projector and the computer.
● Check the mouse setting on your computer.
● Turn on the projector before you turn on the computer.
Wireless mouse function
does not work.
Try these Solutions:
APPENDIX
SERVICE
WARNING: High voltages are used to operate this
projector. Do not attempt to open the cabinet.
You can often correct operating problems yourself. If the
projector fails to work properly, see "TROUBLESHOOTING"
section on pages 51-52. To correct the failure, try the
"Solutions".
Sanyo Services is easily obtained. If after following all
operating instructions, you find that service is necessary,
contact the SFS Corporation in Los Angeles, or the store
where you purchased the unit.
Give the model number and explain the difficulty. We will
advise you how to obtain service.