4
• Position track 2 with the grooved side up. Fit track 2 onto
the center tube.
• Rotate track 2 counter-clockwise until it meets track 1. Insert
and “snap” the tab on the end of track 2 into the slot in
track 1. Be sure the peg on the end of track 2 fits into the
hole in track 1.
• Repeat this process to assemble track 3 to track 2.
Hint: When the tracks are properly fitted on the center tube,
a tab on the center tube should be visible above each track.
9
Track 2
Track 1
Center Tube
• Align the smallest tab on the center tube with the smallest
slot in the base. Push down on the track support to “snap”
the center tube into place.
Base
• Locate track 1. Position track 1 with the grooved side up.
• Fit track 1 onto the center tube. Rotate it counter-clockwise
until it reaches the base.
• Insert and “snap” the tab on the end of track 1 into the slot
in the base.
8
Center Tube
Track 1
Tab
7
Base Slot
Tab
Peg
Hole
Center Tube
Small Tab
Base Small Slot
PUSH
PUSH
• Insert a #6 x
1
/
2
" screw through the hole in track 3 and into
the tube. Tighten the screw with a Phillips screwdriver.
Do not over-tighten
10
Track 3
Center
Tube
#6 x
1
/
2
"- Screw
Shown Actual Size