Filter
Top Products
Introduction
Receiving Inspection and Storage
1
1-3
2. Requirements for proper storage must be documented and written procedures or instructions must
be established.
3. In the event of fire, post-fire evaluation must be in accordance with ANSI N45.2.2 (1972), Section
6.4.3.
4. Removal of items from storage must be in accordance with ANSI N45.2.2 (1972), Sections 6.5 and
6.6.
1.5 Installation
The 960PS-200 and 960PS-210 Power Supply Modules are supplied as part of a radiation monitoring
system (RMS) or as replacement parts for an existing RMS. When the power supplies are shipped as part
of a system, they are installed at the factory.
When a module is shipped as a replacement part, verify the integrity of the gasket, heat sink, and seal
screw fasteners (when used) prior to installation. Apply P/N 88-10 thermal coat, or equal heat transfer
compound between power supply and heat sink to ensure the thermal coupling of the installed power
supply. For operation of the 960PS-210 at 220 VAC, verify the location of the internal supply voltage
jumper E1. The part number of the required mounting hardware may be found in the system assembly
drawing section of the applicable systems manual.
1.6 Procedures, Warnings, and Cautions
The equipment described in this manual is intended to be used for the detection and measurement of
ionizing radiation. It should be used only by persons who have been trained in the proper interpretation of
its readings and the appropriate safety procedures to be followed in the presence of radiation.
Although the equipment described in this manual is designed and manufactured in compliance with all
applicable safety standards, certain hazards are inherent in the use of electronic and radiometric
equipment.
WARNINGS and CAUTIONS are presented throughout this document to alert the user to potentially
hazardous situations. A WARNING is a precautionary message preceding an operation that has the
potential to cause personal injury or death. A CAUTION is a precautionary message preceding an
operation that has the potential to cause permanent damage to the equipment and/or loss of data. Failure
to comply with WARNINGS and CAUTIONS is at the user's own risk and is sufficient cause to terminate
the warranty agreement between Fluke Biomedical and the customer.
Adequate warnings are included in this manual and on the product itself to cover hazards that may be
encountered in normal use and servicing of this equipment. No other procedures are warranted by Fluke
Biomedical. It shall be the owner's or user's responsibility to see to it that the procedures described here
are meticulously followed, and especially that WARNINGS and CAUTIONS are heeded. Failure on the
part of the owner or user in any way to follow the prescribed procedures shall absolve Fluke Biomedical
and its agents from any resulting liability.
Indicated battery and other operational tests must be performed prior to each use to assure that the
instrument is functioning properly. If applicable, failure to conduct periodic performance tests in
accordance with ANSI N323-1978 (R1983) Radiation Protection Instrumentation Test and Calibration,
paragraphs 4.6 and 5.4, and to keep records thereof in accordance with paragraph 4.5 of the same
standard, could result in erroneous readings or potential danger. ANSI N323-1978 becomes, by this
reference, a part of this operating procedure.