Filter
Top Products
Next Steps 33
Next Steps
If you installed the MXL 10/40GbE Switch in a stack, you can configure
additional settings for switch stacking.
For information about how to create different stacking scenarios, refer to the
Ethernet Stacking white paper on the Dell Support and Dell Networking
White Papers websites at:
http://support.dell.com/manuals
http://en.community.dell.com/techcenter/networking/w/wiki/networking-
whitepapers.aspx
For information about how to configure stacking, refer to the User’s
Configuration Guide for the Dell Force10 MXL 10/40 GbE Switch IO Module
on the Dell Support website at http://support.dell.com/manuals.
• You can customize the
MXL 10/40GbE Switch
for use in your data center
network by configuring software features as necessary. To perform
additional switch configuration, do one of the following:
• For remote out-of-band management, enter the OOB management
interface IP address into a Telnet or SSH client and log in to the
switch using the user ID and password to access the CLI.
• For local management, use the attached console connection to log in
to the CLI.
• For remote in-band management from a network management
station, enter the VLAN IP address of the management port and log in
to the switch to access the CLI.
For information about how to configure software settings, refer to the User’s
Configuration Guide for the Dell Force10 MXL 10/40 GbE Switch IO Module
on the Dell Support website at http://support.dell.com/manuals.