FortiOS v3.0 MR7 SSL VPN User Guide
8 01-30007-0348-20080718
About this document Introduction
Whether to use web-only or tunnel mode depends on the number and type of
applications installed on the remote computer. Access to any application not
supported through web-only mode can be supported through tunnel mode. For
more information about these modes of operation, see “Configuring a FortiGate
SSL VPN” on page 13.
About this document
This document explains how to configure SSL VPN operation using the web-
based manager and contains the following chapters:
• Configuring a FortiGate SSL VPN describes the two modes of operation,
recommends a deployment topology, and provides an overview of the
associated infrastructure dependencies. The high-level steps for configuring
each mode of operation are also included with cross-references to underlying
procedures. This chapter also details the basic administrative tasks needed to
support the two modes of operation, and describes the additional step-by-step
procedures needed to configure each mode.
• Working with the web portal introduces the web portal applications and
explains how to work with them. The chapter also explains how to install the
ActiveX plugin and initiate a VPN tunnel when tunnel mode is enabled.
Document conventions
The following document conventions are used in this guide:
• In the examples, private IP addresses are used for both private and public IP
addresses.
• Notes and Cautions are used to provide important information:
Note: Highlights useful additional information.
!
Caution: Warns you about commands or procedures that could have unexpected or
undesirable results including loss of data or damage to equipment.