Fujitsu D1411 Computer Hardware User Manual


 
SCSI/Host RAID-Konfigurationsprogramm Leistungsmerkmale
Standardeinstellungen im Menü Configure/View SCSI
Controller Settings
SCSI-Bus Interface Definitions Standardeinstellung
SCSI-Controller ID 7
SCSI-Controller Parity Enabled
SCSI-Controller Termination Enabled
Additional Options Standardeinstellung
Boot Device Configuration Press <Enter>
Single Image
Master SCSI-Controller AIC-7902 at slot 00 00:04:00
Select SCSI peripheral from which to boot
Boot SCSI-Controller AIC-7902 at slot 00 00:04:00
Boot SCSI ID 0
Boot LUN Number* 0
SCSI Device Configuration Press <Enter>
Sync Transfer Rate (MB/Sec) 320
Packetized Yes
QAS Yes
Initiate Wide Negotiation Yes (Enabled)
Enable Disconnection Yes (Enabled)
Send Start Unit Command**** Yes
BIOS Multiple LUN Support No
Include in BIOS Scan Yes
Advanced Configuration Press <Enter>
Reset SCSI Bus at IC Initialization Enabled
Display <Ctrl><A> Message During BIOS Initialization Enabled
Extended Int 13 Translation for DOS Drives >1GByte Enabled
POST Display Mode Verbose
SCSI-Controller Int 13 Support Enabled
Domain Validation**** Enabled
Support Removable Disks under Int 13 as Fixed Disks**** Disabled
BIOS Support for Bootable CD-ROM**** Enabled
* Die Einstellung ist nur dann wirksam, wenn Multiple LUN Support eingeschaltet (Enabled) ist.
**** Die Einstellung ist nur dann wirksam, wenn der Int 13 Support des SCSI-Controllers
eingeschaltet (Enabled) ist.
A26361-D1411-Z120-3-7419 Deutsch - 15