Filter
Top Products
5
FTP-622DCL/DSL
No. Signal I/O Contents No. Signal I/O Contents
1 MT/B O Stepping motor coil excitation 2 MT/B O Stepping motor coil excitation
3 MT/A O Stepping motor coil excitation 4 MT/A O Stepping motor coil excitation
No. Signal I/O Contents No. Signal I/O Contents
1 +5 V — Power for logic (+5 V) 2 NES I Paper near end detect signal
5. Connector for stepping motor drive (CN13)
Part number : B4B-PH-K-S (J.S.T)
4. Connector for paper near end detection (CN5)
Part number : B2B-PH-K-S (J.S.T)
Mating connector part number : PHR-2 (J.S.T) or equivalent
6. Connector for cutter drive (CN11) *
1
Part number : B4B-EH (J.S.T)
No. Signal I/O Contents No. Signal I/O Contents
1 SW1 I Cutter position detect signal 2 GND — Logic ground
3 M+ O Motor control signal (+) 4 M- O Motor control signal (-)
*1: Only for FTP-622DCL011/111.