Filter
Top Products
3
FTP-622MCL301/302
NOT FOR NEW
DESIGN
Power supply
Dimensions
Part number FTP-622MCL301/302
Interface Centronics (ESC/POS
TM
), RS232C
24VDC ± 5%, Voltage
Current : average
*
2
( ): Peak
For head 0.87 (1.16) A (at 80 mm/s printing speed, 25% printing ratio)
0.63 (1.16) A (at 50 mm/s printing speed, 25% printing ratio)
0.58 (0.58) A (at 30 mm/s printing speed, 25% printing ratio)
For motor 24VDC ± 5%, 1.0 A maximum
For cutter 24VDC ± 5%, 1.0 A maximum
For logic 5VDC ± 5%, 0.5 A maximum
Mechanism (cutter)
101 (W) × 70 (D) × 42 (H) mm (w/cutter)
Interface board 131 (W) × 89 (D) × 24 (H) mm
Weight (Mechanism+Cutter) approximately 300 g (w/cutter)
Pulse durability : 1 × 10
8
pulse/dot (using Fujitsu's standard
Mechanism driving method)
Expected life
Wear resistance: 50 km (at 25% printing ratio)
Cutter 3 × 10
5
cuts
Operating temperature 0 to +50°C
*
3
Operating humidity 20 to 85% RH (no condensation)
Storage temperature –20 to +60°C (excluding paper)
Storage humidity 5 to 95% RH (no condensation)
Head temperature By thermistor (applied energy control, abnormal temperature detection)
Detection Paper out/Mark detect By photointerrupter
Head-up By microswitch
For front insertion use (58 mm width) : FTP-020PU001,FTP-020P0701
For rear insertion use (60 mm width) : FTP-020P0020,FTP-020P0702
*Recommended papers
· Oji Paper : PD150R,PD160R,PD170R
· NIPPON Paper : TF50KS-E,TF60KS-E,TF60KJ-R
· MITSUBISHI Paper Mills : P220VBB-1,AFP-235
SpecificationsItem
(Continued)
Environmental
conditions
Recommended thermal sensitive paper
*1: There may be exceptions.
*2: 24VDC, minimum head resistance.
*3: Guarantee: +5°C ~+40°C.