Fujitsu LQFP-64P Network Card User Manual


 
i
PREFACE
Thank you for purchasing the LQFP-64P*
1
header type 2 (MB2198-304) for the DSU-FR emulator.
This product is used together with the BGA-660P adapter for the DSU-FR emulator (MB2198-
300)*
2
to connect the DSU-FR emulator (MB2198-01)*
3
and DSU-FR cable (MB2198-10)*
4
to a
user system that uses a MB91460 series Fujitsu FR*
4
microcontroller (LQFP-64P)*
5
.
This manual describes how to use the LQFP-64P header type 2 for the DSU-FR emulator. Please read
the manual carefully before using. Please contact your Fujitsu sales or support representative for de-
tails on which production and evaluation MCU models can be used with this product.
*1 : The lead pitch of package (FPT-64P-M23) is 0.65mm and the body size is 14mm × 14mm.
*2 : Referred to as the “adapter”
*3 : Referred to as the “emulator”
*4 : Referred to as the “DSU cable”
*5 : FR is an abbreviation of FUJITSU RISC CONTROLLER and is a product of Fujitsu Limited.
Handling and usage
The handling and use of this product and notes regarding safety use are included in the hardware
manual of the DSU-FR family emulator.
Follow the instructions in for the use of this product.
DSU-FR EMULATOR MB2198-01 HARDWARE MANUAL
DSU-FR EMULATOR DSU-FR CABLE MB2198-10 OPERATION MANUAL
DSU-FR EMULATOR BGA-660P ADAPTER MB2198-300 OPERATION MANUAL
Caution of the products described in this manual
The following precautions apply to the product described in this manual.
CAUTION
The wrong use of a device will give an injury and may cause malfunction on cus-
tomers system.
Cuts
This product has parts with sharp points that are exposed. Do not touch edge of
the product with your bare hands. There is a possibility that it may be injured.
Damage
When connect the header board to the user system, correctly position the index
mark () on the NQPACK mounted on the user system with the index mark ()
on the header board, otherwise the emulator system and user system might be
damaged.
Damage
When mounting a mass production MCU, correctly position pin 1, otherwise the
mass production MCU and user system might be damaged.