Filter
Top Products
C141-E185 IN-3
parts that can be replaced in field....................6-7
physical sector allocation ................................3-5
PLO Sync ........................................................3-8
positioning error rate.......................................2-5
power on/off sequence ............................ 4-8, 4-9
power supply connector ................................4-14
power supply requirement...............................4-8
precaution........................................................6-5
preventive maintenance...................................6-6
programmable data block length.....................1-4
programmable multi-segment data buffer.......1-3
R
random/sequential read test.............................6-5
read/write circuit .............................................1-8
read/write error recovery parameter..............5-20
recommended component for connection .....4-20
reliability .........................................................2-5
reporting result of self-diagnostic
and error indication....................................6-3
reserve and release function............................1-4
revision label...................................................6-9
revision number...............................................6-9
S
SCA2 type LVD 16-bit SCSI.........................B-2
SCA2 type SCSI connector...........................4-12
SCSI bus configuration .................................1-10
SCSI bus connection .......................................5-4
SCSI cable connection ..................................4-19
SCSI connector.......................................B-2, B-3
SCSI connector signal allocation ...........B-2, B-3
SCSI function specification.............................2-7
SCSI ID setting........................................ 5-6, 5-7
SCSI interface error.........................................7-4
SCSI standard..................................................1-2
sector format....................................................3-7
seek test...........................................................6-2
self-diagnostic .................................................6-1
self-diagnostic function...................................6-1
SEND DIAGNOSTIC command ....................6-3
sense data ................................................ 7-1, 7-4
sense data analysis...........................................7-3
sense key, sense code, and subsense code.......7-1
service clearance area......................................4-7
service life.......................................................6-6
service system and repair ................................6-7
setting bus width of SCSI interface.................5-9
setting check list (NP model only) ................5-11
setting of SCSI interface
operation mode ..........................................5-9
setting parameter ...........................................5-19
setting SCSI terminator power supply.............5-8
setting terminal....................................... 5-5, A-1
setting terminal (on NP model only)..............A-2
setting terminal location..................................5-5
setting terminator power supply......................5-8
spare area in cell..............................................3-5
spare disk drive .............................................5-23
specification ....................................................2-1
spindle motor...................................................1-7
standard feature...............................................1-2
START/STOP command...............................5-13
start/stop of spindle motor...............................1-5
storage .............................................................5-2
surface temperature check point......................4-6
surface temperature measurement point..........4-6
system configuration .......................................1-9
system space....................................................3-4
system-level field troubleshooting ................6-14
T
test .................................................................6-10
test flowchart.................................................6-11
test program.....................................................6-4
tool and test equipment .................................6-10
track format.....................................................3-5
track skew and head skew...............................3-6
troubleshooting at repair site.........................6-15
troubleshooting procedure.............................6-13
troubleshooting with disk
drive replacement in field........................6-13
troubleshooting with part replacement
in factory..................................................6-16
U
unpackaging ....................................................5-2
unrecoverable error rate ..................................2-5
user space ........................................................3-3
V
verify error recovery parameter.....................5-20
W
write protect ....................................................5-9
write protect setting.........................................5-9
write/read test..........................................6-2, 6-5