Filter
Top Products
C141-E230 IN-1
Index
A
actuator........................................................... 1-5
additional error recovery parameters.............. 5-8
allowable input voltage and current................ 4-7
alternate area................................................... 3-9
alternate block allocation.............................. 3-10
alternate block allocation by REASSIGN
BLOCKS command................................ 3-12
alternate block allocation during
FORMAT UNIT command execution.... 3-11
alternate spare area ......................................... 3-4
automatic alternate block allocation............. 3-13
automatic alternate block allocation at
read operation ......................................... 3-13
automatic alternate block allocation at
write operation........................................ 3-13
automatic alternate block reassignment.......... 1-3
B
basic operation test ......................................... 6-4
BCRC ............................................................. 3-7
block address of user space ............................ 3-9
block descriptor.............................................. 5-5
C
cache feature................................................... 1-2
caching parameter........................................... 5-9
changing revision number in field.................. 6-8
checking at abnormal end............................... 5-5
checking initial operation ............................... 5-4
checking operation after installation and
preparing HDD for use ............................. 5-4
command queuing feature .............................. 1-3
compactness.................................................... 1-1
connection requirement .................................. 4-8
connector location .......................................... 4-8
continuous block processing........................... 1-2
control mode parameter.................................. 5-9
controller circuit ............................................. 1-5
current waveform ........................................... 4-7
cylinder configuration .................................... 3-1
D
data field......................................................... 3-7
data format...................................................... 3-1
data security at power failure.......................... 2-6
data space ....................................................... 3-1
defect list ...................................................... 3-10
defect management.......................................3-10
defective block slipping..................................1-4
delivery...........................................................5-2
diagnosis.........................................................1-4
diagnostic........................................................6-1
diagnostic test ............................................... 6-10
diagnostics and maintenance ..........................6-1
dimension .......................................................4-1
disk ................................................................. 1-5
disk drive replacement....................................6-7
disk read error.................................................7-4
dismounting drive......................................... 5-10
dual SAS port support..................................... 1-2
E
ECC ................................................................3-7
environmental magnetic field ......................... 4-6
environmental specification............................2-4
environmental temperature.............................4-5
error analysis...................................................7-1
error analysis information collection..............7-1
error information indicated with sense
data............................................................7-3
error rate .........................................................2-5
error recovery .................................................1-3
error recovery during self-diagnostic..............6-3
error recovery parameter ................................5-8
F
factory maintenance........................................ 6-7
field maintenance............................................ 6-7
finding possibly faulty part........................... 6-14
format capacity ............................................... 3-8
format parameter......................................5-5, 5-6
FORMAT UNIT command ............................5-6
formatting ....................................................... 5-5
function specification .....................................2-2
G
gap ..................................................................3-7
general note ....................................................5-1
H
hardware function test ....................................6-2
hardware specification....................................2-1
hardware structure .......................................... 1-5
head.................................................................1-5
high speed positioning....................................1-4
high-speed data transfer..................................1-2