Filter
Top Products
2 - 2 C141-F029-02EN
Table 2.1 Model and parts numbers
Model Part Number Formatted
capacity
Mounting Screw
MPC3032AT CA01675-B321 3243.66 MB
MPC3043AT CA01675-B331 4325.52 MB
MPC3064AT CA01675-B341 6488.29 MB
MPC3084AT CA01675-B561 8455.20 MB
MPC3096AT CA01675-B361 9747.58 MB
MPC3102AT CA01675-B661 10242.74 MB
2.2 Disk Drive Removal
The method and procedures to dismount the disk drive to check the jumper terminal, change
the jumper position, or replace the device differ depend on the system cabinet structure.
Therefore, for actual working procedures, the specific conditions necessary for each system
must be determined. The general removal procedures, with notes, is as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the system cabinet.
c) When storing or transporting the drive, pack it an antistatic bag.
Note:
To protect the device from damage and prevent the worker getting hurt, observe the parts
in Subsection 1.1.1 on Danger and Warnings.
1. Perform any removal after the system power is completely
disconnected. The cable must not be disconnected and the
screws that attach the drive must not be removed with the power
ON.
2. Do not move the drive until it comes to a complete stop (about
30 seconds after the power is turned OFF).
3. Perform the human body grounding to discharge any static
electricity from your body.
No. 6-32UNC