Filter
Top Products
SERIES II 15 AMP POWER CONDITIONERS
WA R N I N G
To reduce the risk of electrical shock, do not
expose this equipment to rain or moisture.
Dangerous high voltages are present inside the
enclosure. Do not remove the covers. Refer
servicing to qualied personnel only. The
lightning ash with an arrowhead symbol is
intended to alert the user to the presence of
un-insulated dangerous voltage within the
product’s enclosure that may be of sufcient
magnitude to constitute a risk of electric shock.
I M P O R TA N T S A F E T Y
I N S T R U C T I O N S
(Please read prior to installation)
1. Please read and observe all safety and
operating instructions before installing your
Series II unit. Retain these instructions for
future reference.
2. Your Series II unit should not be used near
water – for example, near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet basement,
near a swimming pool, etc.
3. Do not place your Series II unit near heat
sources such as radiators, heat registers,
stoves, or other appliances that produce heat.
4. The PL-8 II, PL-Plus II, PL-Plus D II, and PM-
8 II should only be connected to a 120 VAC,
60Hz, 15 amp grounded electrical outlet. Do
not defeat the ground or change polarization of
the power plug. (E- versions 220 – 240 VAC 50 Hz. /
J- versions 100 – 120 VAC 50 Hz.)
5. Route the power cord and other cables so
that they are not likely to be walked on, tripped
over, or stressed. Pay particular attention
to the condition of the cords and cables at
the plugs, and the point where they exit your
Series II unit. To prevent risk of re or injury,
damaged cords and cables should be replaced
immediately.
6. Clean your Series II unit with a damp cloth
only. Do not use solvents or abrasive cleaners.
Never pour liquid on or into the unit.
7. Your Series II unit should be serviced by
qualied service personnel when:
• The power supply cord or the plug has been
frayed, kinked, or cut.
• Objects have fallen or liquid has spilled into
the unit.
• The unit has been exposed to rain or other
moisture.
• The unit does not appear to operate normally.
• The “Protection OK” indicator is not lit.
• The unit has been dropped, or the enclosure
has been damaged.
• The retractable LED lights have failed. (not
applicable to the PM-8 II)
8. Your Series II unit requires that a safety
ground be present for proper operation. Any
attempt to operate the unit without a safety
ground is considered improper operation and
could invalidate the warranty.
9. Do not attempt to service your Series II unit
beyond what is described in this manual. All
other servicing should be referred to qualied
service personnel.
ADDITIONAL F E A T U R E S
PL-8 SERIES II
3