GBC 7120S Paper Shredder User Manual


 
FIGURE 1.
4-.-/
,
~
~
FIGURE 2.
~,
SET UP-FIGURE 1, 2 & 3
To protect against damage your shredder has been shipped in two paris, the shredder
head (FIGURE 1.A) and the cabinet (FIGURE 1.8).
~ Caution! Shredders are heavy equipment (see "Shredder Head Weight" in the
.."Specifications" section of this Manual). To insure proper installation and avoid
injury, GBC recommends that two people set up this unit. Use care not to pinch your
fingers between the shredder head and cabinet. Handle shredder head as illustrated.
1. Using the hand grips (FIGURE 2.A) provided, place the shredder head onto the top
of the cabinet. The control panel may face toward the front or back of the cabinet.
2. Open the door by pressing on the door knob (FIGURE 2.8) and place the hand grips
(FIGURE 3.A) into the holes found in the cabinet floor (FIGURE 3.8).
3. Remove the wire bag rim and place one of the shred bags onto the rim. Slide the rim
with bag back into the cabinet. Close the cabinet door.
4. Connect the power cord to a standard, single phase socket. Fuse: 15 Amp. Max.
5. After reading the operating instructions, slide them into the holder (FIGURE 3.C)
and close the door.
I Your shredder is ready for use!
;:-
-01
FIGURE ~
~
~ ' .:
/i. ) ,
'I
--- tli / ' ,
+- f ~- : !
-.i,/ --,
OPERATION-FIGURE 4.
Press the rocker switch (A) to the Power ON 'I' position. When the shredder is properly
set up with cabinet door fully closed, the Power ON '1' light (8) will illuminate.
You are now ready to shred!
To shred simply insert paper into the throat of the unit. Once your document has
activated the automatic on feature, the unit automatically will start and then will stop once
your document is shredded.
BIN FULL ~
In order to prevent shreds from backing up into the cutters and jamming your shredder,
this unit features an automatic bin full shut off. Once the shred bin is full, the
unit will shut off automatically and the bin full light (C) will illuminate. You can now
either compact the shreds and continue shredding, or empty the shred bag.
NOTE: For safety reasons, whenever the cabinet door has been opened this unit will not
operate until the door is closed and the unit is switched off and then back on.
DOOR AJAR C1
Your shredder is equipped with a safety interlock which will not allow the unit to operate
if the cabinet door is open. The Door Ajar light (D) will illuminate if your cabinet door is
not fully closed.
OVERLOAD R
If too much paper is inserted into the throat of the unit, the shredder will sense an
overload and shut off automatically to avoid unnecessary motor heating and the Overload
Light (E) will illuminate. To clear the overload, switch the unit to Reverse 'R' mode until
the paper is clear of the throat area. Switch your unit back into the Power ON 'I' position,
separate your pages into smaller sets and shred.
II;
ABC Office
800.658.8788
www.abcoffice.com