Filter
Top Products
Tecnología antiatascos
Shredmaster
Las destructoras de papel Shredmaster sólo destruyen pilas de papel adecuadas
a su capacidad de hojas. P.ej. Si una destructora tiene una capacidad de entre
12 y 18 hojas, no permitirá la destrucción de un número mayor de hojas.
Los sensores situados en zona de alimentación de papel miden el grosor del
papel que va a destruirse. La posibilidad de destruir o no el papel se comunica
mediante las luces roja y verde. La luz verde significa que la pila de papel está
dentro de la capacidad de hojas de la destructora y ésta está preparada para
destruir. La luz roja significa que la cantidad de papel es excesiva y debe quitar
algunas hojas para poder destruirlas.
Dado que no puede destruir más hojas de papel que las indicadas por su
capacidad de destrucción, se evitan los atascos del papel.
Ahorra el tiempo que se pierde recuperando el papel y desbloqueando los
atascos, sin mencionar el desorden que puede causar.
Technologie antibourrage
Shredmaster
Les destructeurs Shredmaster ne pourront détruire un nombre de feuilles
dépassant leur capacité de coupe. Par exemple, un destructeur d’une capacité
de coupe de 12 à 18 feuilles ne vous permettra pas de détruire simultanément
un plus grand nombre de feuilles.
Des capteurs situés dans l’aire d’alimentation du papier mesurent l’épaisseur
de la liasse à détruire. Le destructeur indique sa capacité à détruire ou non la
liasse entière par le biais d’un voyant lumineux vert ou rouge. Vert signifie que la
liasse respecte la capacité de coupe du destructeur et peut être détruite. Rouge
signifie que la liasse est trop épaisse et que vous devez retirer quelques feuilles
avant la destruction.
Comme il vous est ainsi impossible de détruire un nombre de feuilles excédant
la capacité de coupe du destructeur, les blocages sont évités.
Plus de perte de temps à renverser la marche et retirer le papier, ni à nettoyer le
désordre occasionné.
Shredmaster
®
Jam Free Series
TM
Technology Shredders will only shred
stacks of paper that are within the shredders sheet capacity. Eg. A shredder
with a capacity between 12 and 18 sheets will not allow the shredding of
more sheets than this.
Sensors in the paper feed area measure the thickness of paper about to
be shredded. The ability to shred or not is communicated through red and
green lighting. Green means that the stack of paper is within the shredders
sheet capacity and OK to shred. Red means that you have too much paper,
remove some sheets in order to shred.
Given that you are unable to shred more sheets of paper than the shredder
is capable of shredding, paper jams are prevented.
This prevents time wasted through reversing paper and unblocking jams not
to mention the mess it can create.
ShredMaster® JamFree Series
Technology
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
FCC Class B Notice
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference
that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
* Reor ient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
* Consu lt the dealer or an experienced radio/television technician for help.
Foil Shielded Cables:
Connect ions between the IdeaShareTM board and computer and other
devices must be made using foil shielded cables in order to maintain
compliance with FCC radio frequency emission limits.
Modifications:
Any modifications made to this device that are not approved by General
Binding Corporation may void the authority granted to the user by the FCC to
operate this equipment.
Canad a Class B Notice - Avis
Canada, Classe B
This Class B digital apparatus complies with Canadian ICES-3.
Cet appareil numérique de la classeB estconforme à la norme NMB-003 du
Canada.