Filter
Top Products
5
Operation
1
Plug in shredder.
2
Press the central power on button (d). This will switch the power on
and all the LED warning symbols on the indicator panel (a) will flash
in sequence. The shredder will now be in standby mode and the
“Power-on” symbol on the indicator panel will be illuminated amber.
3
To commence shredding, press the right hand auto feed button (e) this
will illuminate the feed area green and illuminate the
symbol green.
This sets the shredder into auto mode and initiates the Jam-Free Series
mechanism. You are now able to shred.
4
Insert paper to be shredded into the feed area. The Jam Free Series
mechanism will sense the thickness of the paper being shredded.
If the paper thickness is within the shredders capacity the motor will
start and your documents will be shredded. Cutters will stop once the
shredding process is complete.
If the paper thickness is greater than the shredders sheet capacity the
area around the feed slot will turn from green to red and the motor will
not run. In this situation the Jam-Free Series Icon on the indicator panel
will flash red, the green
will go off, instead the will be illuminated
red.
5
If this happens, remove some of the sheets from the paper stack and
re-try until the feed area reverts back to green, the shredder will then
automatically start and allow the paper to be shredded.
If the shredder is left in auto mode for more than 10 minutes without
being used, the shredder will automatically turn back to standby mode
in order to save power.
Reverse Function
1
Should you wish to reverse the shredding direction while shredding
a document, a reverse button (f) has been fitted for your convenience.
2
By pressing the reverse button, the shredding cutters will change
direction allowing the retrieval of the document being shredded.
The feed area will turn to red.
3
The reverse function will only run while the button is being pressed.
When the reverse button has been released the shredder will revert
to stand by mode.
4
To turn back to auto mode simply press the right hand auto feed
CD and Credit Card Shredding
The Jam-Free Series models can also shred CDs and credit cards.
1
Pull up the orange CD guide (g) located in the centre of the feed area
and flip it into position over the shredder mouth.
2
For credit card shredding, switch the shredder to auto mode and insert
the card into the centre slot.
3
For CD shredding, extend the sides of the orange CD guide, switch the
shredder to auto mode and place the CD into the centre of the CD slot.
Only 1 CD or credit card can be shredded at a time.
Jamming Situations
In the unlikely event of the shredder jamming, use the reverse function to
unblock the shredder. (see Reverse function section)
Alternating between the reverse function and the forward run (Hold Auto
start for 2 seconds) will help unblock the feed area.
Once the jam is clear, press the right hand auto button once to revert back
to auto mode. You can now resume shredding as normal.
Bin Full
When the bin is full the shredder will not function and the bin full symbol
will illuminate and flash red, the green
will switch off and the will
illuminate red.
When this happens you must empty the bin.
• Pull open the drawer to empty. (
RSX128
)
• Open the door to locate the bin (
RDS1713, RDX1413, RDS1819,
RDX1619
)
Once the bin is empty, close the door/drawer and press the auto button to
resume shredding.
Door Open Safety Function
If the door is opened during shredding as a safety precaution the shredder
will instantly stop, and the door open symbol on the indicator panel will flash
red. The green
will go off and the red flash will illuminate. To resume
shredding, shut the door and press the auto button.
Over Heating
If the shredder is used continuously for long periods of time the shredder
may overheat. If this occurs the thermometer symbol on the indicator panel
will flash amber, the green
will go off and you will see the red .
When the shredder is ready to be used again the thermometer symbol will
stop flashing and the green
will show once again. To resume shredding
press the auto button.
Shredder Waste Bags
GBC
®
shredder waste bag 1765010 should be used with models
RDS1713,
RDX1413, RDS1819, RDX1619
. We recommend that no waste bag is to
be used for model RSX128.