GE PDW8700 Computer Drive User Manual


 
Installation Instructions
Align the toekick with the bottom edge and make
sure it is against the floor.
Insert and tighten the two toekick attachment
screws. The toekick should stay in contact with the
floor.
TIP: Make sure toekick is against floor to minimize
noise.
Figure JJ
STEP 19 LITERATURE
Be sure to leave complete literature package and
installation instructions with the consumer.
STEP 18 REPLACE TOEKICK
Place toekick against the legs of the dishwasher.
STEP 17
DISHWASHER WET TEST
Turn on power supply (or plug power cord into
outlet, if equipped).
Start the unit to check for leaks.
PDW8100-PDW8800 Series:
Latch door
Push RINSE ONLY pad
Push START/RESET pad
PDW9200-PDW9800 Series:
Push RINSE ONLY pad
Push START/RESET pad
Close door
Push Rinse Only button.
Push start/reset pad once.
Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to be
sure that water and power are turned on.
Check for leaks under the dishwasher. If a leak is
found, turn power supply off, then tighten connec-
tions. Restore power after leak is corrected.
Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the dish-
washer if necessary. See Step 12.
The dishwasher will drain and turn off about 5
minutes after it was started. Check drain lines. If
leaks are found, turn power off at the breaker and
correct plumbing as necessary. Restore power
after corrections are made. See Step 14.
Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 14. Also check drain line for kinking.
Run the dishwasher through another Rinse Only
cycle. Check for leaks and correct if required.
Toekick
Attachment Screws
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE