Filter
Top Products
11
Cable Tie
Cable Tie
Cable Tie
Laundry Tub
Stand Pipe
WARNING
: Make sure the washer is unplugged.
Run some water from the hot and cold faucets to flush
the water lines and remove particles that might clog up
the water valve screens.
FLUSH WATER LINES
1
Installation Instructions
WASHER CONNECTIONS FOR STATIONARY MODEL WSLS1500
Connect the inlet hose ends to the HOT and COLD water
faucets tightly by hand, then tighten another
2
⁄3 turn with
pliers. Turn the water on and check for leaks.
CONNECT TO WATER LINES
2
CAREFULLY MOVE THE WASHER TO
ITS FINAL LOCATION
3
Form a U shape on the end of the drain hose with
the hose pointed toward the drain. Place the hose in
a laundry tub or stand pipe and secure it with a cable
tie (not included).
NOTE: If the drain hose is placed in a stand pipe without
forming a U shape, a siphoning action could occur. There
must be an air gap around the drain hose. A snug hose
fit can also cause a siphoning action.
CONNECT DRAIN HOSE
4
PLUG THE POWER CORD INTO A
GROUNDED OUTLET
5
Insure proper ground
exists before use