Filter
Top Products
5
1 Infrared (IR) Receiver Extension Port
This port will accept an optionally purchased IR extension cable (Gefen part#
EXT-RMT-EXTIR). This is useful for installations where the IR receiver, located
on the front panel (Item 2 on this page), is not in line-of-sight with the IR remote
control used to relay commands to the device at the sender’s location.
2 Infrared (IR) Receiver
This IR receiver will relay IR commands from the receiving unit to the sending
unit for output to a IR transmitter (blaster) on a IR controllable device.
3 Currently Selected Input LED Indicator
There is one LED for each of the eight HDMI input ports. The LED for the
currently selected HDMI input will be active.
4 LED Power Indicator
This LED will become active once the included 5V DC power supply is properly
connected between the sender and an open wall power socket.
5 RS-232 Serial Communication port
This port will accept a DB-9 serial communication cable for control by a separate
device. This port only uses the send, receive, and ground pins. Please see page
9 for more information.
6 5V DC Power Receptacle
This receptacle will require power from the included 5V DC power supply for
proper operation. Connect the included power supply between this port and an
open wall power socket.
7 HDMI Input Ports 1-8
Connect up to eight HDMI source devices to these HDMI input ports. Selection
of the viewable input is executed by the included RMT-8IR remote control or by
an external device that uses the RS-232 serial communication port.
8 HDMI Output Port
Connect one HDMI capable device (i.e. HDMI display) to this HDMI output port.
The currently selected HDMI input source device will be output through this port.
PANEL DESCRIPTIONS