Filter
Top Products
Warning:
ID Link should be completed within 10 seconds, otherwise the connection would
be failed.
Low Battery Alert
When battery power drops down to 2V, the alert
LED on the left side of the Mouse starts flashin
g
.
Please charge batteries for 4 hours but not exceed
24 hours.
Charging Batteries
A. Plug 1.3mm DC jack (black) into Receiver DC socket.
B. Plug 1.0mm DC jack (silver) to Mouse DC socket. Batteries charge begins and
the alert LED of the mouse lightens constantly.
C. When Alert LED fades out, charge is full and make sure you disconnect the DC
Jack Cable.
NOTE:
1. Charge the batteries to full when you insert new batteries for use the first time.
8 hours battery charging is recommended.
2. Don’t charge when no batteries are loaded.
3. Be sure DC Jack is plugged into the correct socket. Any other incompatible
facilities should not be connected with Receiver socket.
4. Only NI-MH 600mAh 1.2V AAA batteries authorized should be used.
5. DC Jack cable should not be used to charge other devices.
Power Saving Mode
A. Suspend Mode:
Keep Mouse stationary for 10 minutes, then it will be automatically set to
Suspend Mode. Press the left button to wake up the Mouse again.
B. Power Off Mode:
When you wish to set the mouse to power off mode, press mouse ID for 3
seconds.
The optical LED will flash once and then fade out,
showin
g
Mouse power is already off. Press the ID
switch for waking it up again.
Dual Mode
The unique feature of “Dual Mode” allows you to use the Mouse even when the
battery power is low. This feature is designed to keep this Mouse running all the
time.
When the Low Battery Alert is shown, just connect the bundled DC Jack Cable to
the Mouse and Receiver. This wireless mouse is able to keep operating as a wire
mouse without any interruption.
Besides, the regular Nokia mobile phone DC adapter (battery charger), e.g.
ACP-7, ACP-8, ACP-9, LCH-9, DCH-9, etc., also can be used to charge the NiMh
battery too. The recommended DC adapter voltage output is 5V and current
output is 500mA.
Warning:
Any improper charging operation may damage the Mouse and could be
dangerous. For more details, please refer to “Charge Batteries” section and Nokia
mobile DC adapter user manual.
Only Rechargeable Ni-MH batteries can be used! Charging normal batteries with
this device will void the warranty!
Trouble Shooting
A. When the Mouse doesn’t respond, check the battery power status,
and link ID if necessary.
B. Be sure the two DC Jacks being connected to the DC sockets of the
right respective mouse or receiver.
C. Check the battery pole if the optical LED is still off after inserting
batteries.
D. Please do use the accessories (DC Jack Cable) attached, if DC Jack
Cable is defective, then Nokia charger (5.03V / 500 mA regulated
voltage function) can be used.
E. Check the DC Jack Cable if it is well connected when Low Battery
Alert LED never fades out.
F. Ask for maintenance solution from your retailer and or an authorized
service center. Do not attempt to service the notebook yourself, it
may void your warranty to this product.
Ҹ
ᓏ
џၒϽְޜ
…………………………….…………………………..2
FCC
ݳཚٽ༂
….……………………….........….........…3
ഋ௱Ⴗဪ
……………………………..........……………………4
ԖၒႷԽ
…………………………………………………………….4
ᡜ؍พጯഋጯᓨႊ………………………….……………….…..5
տႷមҼ
………….………….............….....……………5
ࣛႷԽєႷ
…………….............................………….6
ऄႷውԞ
……………….........................……………….7
ᚢॳውԞ
….……………………………....................……7
ሷంୂ
………………………….........…………….…………8