Filter
Top Products
System Configura
tion
Add or Remove Devices
After gateways are set up, use the Devices section
to add or remove Graco devices.
1. Click Devices
>> Add.
a. Gateway drop down: Choose a gateway
through which the AWI will communicate
with Graco devices. For example, if you are
adding a ProMix, select TCP Local.Ifyou
are adding an Informer or a ProControl 1KE,
select Modbus TCP Local.
b. Device name: Type the name of your
choosing in the field, for example, Informer2.
c. Device address, ProMix: Type in the IP
address that you set up on the EasyKey.
d. Device address, Informer or ProControl 1KE:
Type in the modbus addresses (1–247) that
you set up.
2. Click Add.
a. Successful Ad
d: A check mark appears
(briefly) in th
e upper right hand corner of the
screen. Then,
the Network Tab appears with
the new devic
e listed.
b. Unsuccessfu
l Add: An exclamation point
appears in th
e upper right hand corner of the
screen. Clic
k Cancel. On the Network Tab
select Gate
ways >> Remove. Double check
that your ga
teway address is correct. If it is
not correct
, click Remove. Add the gateway
again, with
the correct address. Then try
adding you
r device again.
332459A
21